answersLogoWhite

0


Best Answer

The Bell-Coleman Cycle is also known as the Air-Standard Refrigeration Cycle or Reverse Brayton Cycle. This 4-process refrigeration cycle involves isentropic compression, followed by isobarric heat rejection, then isentropic expansion (usually by a turboexpander), and finally isobarric heat intake.

This cycle is commonly used in jet aircraft, using engine bleed air for compression and venting to the atmosphere. It is also commonly used in commercial air liquification plants.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Bell Coleman Cycle it is the air refregeration cycle?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Who are the Phillies to hit for the cycle since 1963?

David Bell


What is special about a bell frog?

Bell frogs have a croak that sounds like a motor cycle changing gears.


When was Coleman Bell born?

Coleman Bell was born on 1970-04-22.


Why does the sound stop when the ringing bell of the cycle is touched?

The ringing sound is created from vibrations of the bell. When you touch the bell, your fingers or hand dampens or stops the vibrations of the bell.


What are Bell Frogs?

== == Bell frogs are the largest type of frogs. They have slimy and moist skin. They are usually green and golden but there are many different colours. Bell frogs' croaks soung like a motor cycle changing gears.


Who sells women's cycle jerseys?

I have some from my ex wife In my garage I bring some to taco bell meet me there at 7:24 a.m


When was Charles Bell - painter - born?

Charles Coleman - English painter - was born in 1807.


What happens to the armature and the hammer when the electric bell is switched on?

When power is applied to the armature coil, the armature which has the hammer attached to it is drawn into the coil. The bell is struck by the hammer. At the end of the hammer stroke there is a N.C. (normally closed) contact which is opened. The opening of the contacts stops the current flow to the armature coil and the armature and hammer return to the off bell position. In the off bell position the N.C. contact re closes and the cycle is repeated over again. This cycling will continue until the bell circuit is turned off.


Why would the seatbelt light on a 1990 Nissan Maxima keep coming on and going off even when you have your seatbelt on?

nissan designed the seatbelt warning light to flash i think around 7 times. there is also a warning bell with the light, however the bell deactivates once the drivers seatbelt is locked in, where as the light continues the full cycle. Naaman


Are there any third generation major league baseball players?

Yes. Jerry Hairston Jr, Mike Bell, Aaron Boone and Casey Coleman


Frequency of ring of an electric bell?

Typically the frequency of the AC electrical current feeding the bell. This can be 50CPS or 60CPS depending on the country. Sometimes bell manufacturers put a diode in series with the bell circuit that lops off half the current cycle creating either a 25cps or 30cps bell ringing frequency. Old electromechanical central offices used to ring the bell on party line phones with different frequencies. Each subscriber had a capacitor tuned to the bell coil that was "excited" at a different natural frequency allowing up to 4 people to share a single phone line and be individually notified of a call for them. The frequencies they used were 20, 30,40, 60 cps.


Who is Taco Bell barbacoa girl?

The actress' name is Kelen Coleman... If you watch the Office, you probably recognized her from playing Isabel, one of Pam's bridesmaids at the wedding.