There are a total of 19 fasteners that hold the water pump to the 4.9 engine;
4 #45 Torex (the heads are a female star pattern so you will need a male tool)
7 10mm nuts
1 15mm stud (you will need a deep socket)
7 10mm bolts
Now listen-up, this not an easy job, and professionals screw it up all the time. So take your time and pay attention to how it comes apart.
you will need to make a bolt map, so take the new pump or gasket and draw an outline on a piece of card board. as your fasteners come off, push them into the cardboard where they go.
Once you get all of the other stuff out of the way start by taking the pulley off (3ea 13mm bolts) don't skip this step because there are two bolts behind it.
Clean off the place where the gasket goes to bare metal on the engine (use razor blades and scotch brite pads).
Use some permatex water pump sealant on both sides of the gasket.
Next, the big Torex bolts and the 15mm stud take 30 Ft Lbs of torque but all of the 10mm bolts / nuts only take 5 ! any more and they will pull the studs / threads out !
Good luck.
On water pump
wiring a starter for a1992 cadillac seville
No. it will not fit.
Any type of SAE certified antifreeze can be used in your 1992 Cadillac Seville. The antifreeze should be rated for -35 degrees to 120 degrees.
Depends on what Car Of The Year you are referring to.= The 1992 CADILLAC SEVILLE was the Motor trend car of the year=
Behind the glove box
15mpg city/23mpg hwy.
180 to 190
yes there is you have to get it from a cadillac dealer or you can buy an after market one from walmart
92-97 Seville
there is a fusebox in the trunk (on lefthand wall).
I have the same problem somebody please HELP