usually depends on the type of vehicle that you are driving. if it is equiped with a third light and it works then it will either be the rear bulb assembly or the problem is under the dash board in the wiring. please check these and get back to me and i will walk you thru the process of fixing them
Fuse is good break lights still don't work all the bubls work
brake lights dont work
change the brake lights check the fuse check the brake light swtch
Check the fuse, the bulbs, and the brake light switch.
Brake pedal switch, wiring, bulbs, bad trailer harness (if there), fuses...
all my lights work except my break lights, when i push on the peddle they dont go on can you help me?
i got a 2006toyota highlander my tail lights dont work but,every other light works please help me
Did you replace the fuse? have you checked the circuit board well the lights go on cause they tend to short out often
Check the brake light fuse. If you have 12 volts at the brake light switch I would suspect the signal light switch is at fault.
I am having the same trouble. My brake lights work with the light switch for nighttime driving, but only far right brake light works when i pres brake pedal. Reverse lights dont work at all. Turn signals and hazard light work.
my back brake lights don't work, but the brake light on the back door does what could be wrong
If the headlights are on and brake lights work but not the tail lights, it is possible there is a short in the electrical wires. Another cause for this could be that the tail light bulbs are burned out. Most vehicles have more than one bulb inside the tail lights to control different lights at the same time.
yes my brake lights dont work First check the fuses, then check the bulbs then check the brake light switch