your switch my need adjusted or replaced
Brake switch needs replaced.
check the wires at brake light switch on brake pedal they are bad about breaking brake light switch
The brake light switch might not be connected properly. Remove the brake light switch for 10 seconds and replace it to its original position.
Check the bulbs- they are double filamented with the smaller for brake lights Check the fuse Check the sockets for power and ground Check the sockets for corrosion
Your brake light ignition switch should be replaced. It works your brake lights and ignition switch, so you do need it. It only costs about $7 dollars.
Check the petal and make sure that the plastic part that touches the brake light switch when the petal is in contact with the brake light switch is still on the petal, if it is missing you will need to replace it, so the petal will make correct contact with the brake light switch.
Check the brake light fuse. If you have 12 volts at the brake light switch I would suspect the signal light switch is at fault.
The switch isn't repairable and should be replaced if bad. It's located on the bar where the brake pedal is attached.
Out of adjustment. Adjust the mounting of the switch so the brakes lights are off until you press the brake pedal.
If you replaced the brake switch it sounds like you put the new one on backwards.
Check sockets and grounds
if it isn't a fuse or lamp problem, check the brake lamp switch on the brake pedal, if you unplug the switch, and jumper the connection, and you have brake lamps, replace the switch...
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
brake pedal light switch.
The turn signal switch overrides the brake light circuit while the turn signals are on. If the switch is damaged or worn out the brake lights won't work.
Check the brake switch located on your brake pedal shaft. May have to be replaced.
i have tail lights but do not have brake lights nor do i have turn signals. i have replaced brake switch and all bulbs
When break lights do not turn off when the brake pedal is fully retracted suggests two possible causes: * The brake light switch is out of adjustment and needs to be adjusted. * The brake light switch is defective and needs to be replaced.
already changed brake switch but cant shift form P
try swapping wires on brake light switch--do stop lights work?
Check the brake light switch. This can cause the brake lights to go out. There have been a couple of recalls on the 2001 for this exact problem. Contact your local VW dealer and have the switch replaced.
Check the switch at the brake pedal, it is what makes the brakes come on, it may be malfunctioning.
"Stuck" brake lights indicate that the brake light switch on the brake pedal is broken. It should be replaced.
The brake lights won't turn off because the brake light switch on the pedestal of the brake pedal needs to be replaced.