answersLogoWhite

0

Break job 2001 Hyundai Elantra

User Avatar

Anonymous

16y ago
Updated: 8/17/2019

step by step instructions Break job 2001 Hyundai Elantra

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How to change a wheel bearing in a 2000 Hyundai elantra?

It is a tough job and requires the removal of the hub in most cases which unfortunately requires the removal of a lot of other suspension components in most cases also as the Hyundai's tend to seize up from rust and corrosion.


How much does a valve job cost for a 2001 Hyundai Santa Fe 4 cylinder?

The cost of a valve job for a 2001 Hyundai Santa Fe with a 4-cylinder engine typically ranges from $500 to $1,500, depending on the labor rates in your area and the extent of the work required. This price can vary based on whether parts need to be replaced, such as valves, seals, or gaskets. It's advisable to get quotes from local mechanics to get a more accurate estimate.


Where is the starter on a 2006 Hyundai Elantra?

You are not going to like where it is. You have to remove the air filter housing, as it is below this component, and unless you have arms the size of a baby, as well as being elastic, you are better off taking the part to a garage that has a hoist, and the tools necessary to complete the job. It is just in a mean place to get at.


How do you change the rear brakes on a 2005 Hyundai Elantra gt?

I just did this yesterday. It is a little different from the fronts in that the caliper will need to be depressed with a pair of needle nose pliers and not a c clamp as on the front. Other than that it is normal 14 mm socket to do the job. The fronts will require a 17 mm socket.


How do you change the timing belt on a 2002 Elantra?

Take this to an expert fro the repair. This is not a DIY job for the inexperienced.


How do you change a bulb on the dash of a Hyundai Santa Fe?

ohhhhhh big job friend,,,big job


When should the timing belt be changed on a 2002 Hyundai Elantra?

Most Hyundais recommend changing the timing belt every 60,000 miles. However, I am at 77k and haven't changed it yet. I need to change it ASAP.AnswerI have a 2001 Hyundai elantra. and You are supposed to change it at 60K miles but! i am at 66,000-ish! and I am now noticing a slight movement prob every once in a while! YEA GET THAT STUFF DONE! Have you ever noticed when one prob goes wrong with the car ALL GOES AT ONCE!!! AnswerGot a 2000 Accent that went 73K but then the belt went too. Had to get some bent valves repaired....change the belt. i suggest chaging rubber timing belts at 50,000 i have seen alot of bent valves and cracked heads and pistons from neglecting this a $200 job can easily turn into $1000


What are the ratings and certificates for The Job - 2001?

The Job - 2001 is rated/received certificates of: Australia:PG


What are the release dates for Oswald - 2001 Job for a Day?

Oswald - 2001 Job for a Day was released on: USA: August 2001


Does spartacus like his job and why?

Its obvious that Spartacus did not like his job. He started a revolt to break away from it.Its obvious that Spartacus did not like his job. He started a revolt to break away from it.Its obvious that Spartacus did not like his job. He started a revolt to break away from it.Its obvious that Spartacus did not like his job. He started a revolt to break away from it.Its obvious that Spartacus did not like his job. He started a revolt to break away from it.Its obvious that Spartacus did not like his job. He started a revolt to break away from it.Its obvious that Spartacus did not like his job. He started a revolt to break away from it.Its obvious that Spartacus did not like his job. He started a revolt to break away from it.Its obvious that Spartacus did not like his job. He started a revolt to break away from it.


Do you have to the change water pump when you change the timing belt on my renualt senic 1.4 2001?

It is not mandatory. but i would recommend it as it is a bothersome job to take it apart again if it does break.


Where is the blower motor on a Hyundai Tiburon?

The blower motor on a Hyundai Tiburon is located inside the heating and air conditioning duct. Its job is to circulate the air in the car.