110, 115 and 120 volts are a nominal figures in the same voltage range. It is brought about by the power company, as they have a responsibility to keep voltages within a certain 10% range. The load will only notice a difference of 1% on the load current. eg. Wattage load of 2400. Amps = watts/volts. 2400/110V = 21.8 amps. 2400/115 = 20.86. 2400/120V = 20 amps. On a constant resistance as the voltage goes lower, the current goes higher and vise versa as the voltage goes higher, the current goes lower.
Yes - usually house voltage varies from 110 to 120 volts.
The appliaance is designed for 110-120 v so if it is fed at 115 v that is quite OK.
on a standard 110-120 volt recptical the larger contact is the neutrial (white)side the smaller contact is the "hot" side
Equipment works over a range of voltage and should be interchangeable between 110 v and 120 v so the answer is yes.
Yes, the rating on the receptacle is the maximum amount of voltage that is legally allowed to be applied to the device.
Yes. Circuits in a home are 120 volts but people tend to call them 110 volt circuits. The 120 volts you read on the appliance is the maximum voltage the appliance can handle. The actual voltage you will read at any outlet will range from 110 to 120 volts.
Only use 110-120 volt appliances on a 110 volt socket.
Typically residential voltage may range from 110 to 120 volts so there should be no problem.
Yes.
Yes - usually house voltage varies from 110 to 120 volts.
No conversion needed. These are nominal voltages which range from 110 to 120 volts. It will operate fine on the outlet.
115 Volt and a 110 Volt can be treated as the same thing. The electrical voltage supplied from your electric company is not exact and can be 120 Volt + or - 10%.
The appliaance is designed for 110-120 v so if it is fed at 115 v that is quite OK.
Yes - a hair-dryer rated at 120 volts will work in a 110 volt outlet.
temporary it blows or KABOOOMM....
Yes, the two voltages are in the same voltage range.
on a standard 110-120 volt recptical the larger contact is the neutrial (white)side the smaller contact is the "hot" side