The glove department must be hooked on the three latches. If not, then the glove box will not close.
All you have to do is, When the glove box is open just open it again when it's closed. hope this helps.
The blower motor is behind the glove box. 3 screws below the glove box to expose the glove box bracket then 2 more to take the glove box off.....its big and silver...cant miss it!
Well, i cant speak for any one else, but i have torture tools behind my glove box.
You Cant Close It!
check out this thread. should help http://www.subaruforester.org/vbulletin/f88/cant-remove-glove-box-remove-cabin-filter-37003/
behind glove box in heater housing. just push glove box stops and let it flip all the way down. you cant miss it.
Its right in behind the glove box you cant miss it Flex both sides of the glove box bin inward near the top far enough for the rubber glove box stop bumpers to clear the sides of the glove box opening, then roll the glove box downward. The resistor is right there in the center held in with 2 screws and 2 harness clips for the wires.
its is located under the glove box. Remove three screws inside the front edge of the glove box, close it and remove three screws just below the glove box. Has three clips holding in the whole glove box, pull to remove the whole box. filter has two clips holding it in.
You cant, go to the junk yard or eBay
some of them had a glove box light inside the glove box.
on 94 and earlier models it is located behind the glove box or close to the ECM.