Want this question answered?
no
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
No, the voltage of 500 volts is too high to operate a 380 volt motor.
It would not be immediately dangerous but there is a possibility of overheating with the 9% overvoltage so it isn't a good idea unless the motor is lightly loaded and watched very carefully. The safe voltage range should be marked on the motor.
230V/1Ph/50Hz 1HP (0.75 kW)Motor Capacitor start induction motor ( single phase)
no
The speed of a single phase digital meter 1600mp or kWh 50HZ can be reduced. By decreasing the voltage to reduce the speed of the single phase digital meter the motor is to decreased in speed meaning the consumer load will be decreased as well.
Yes, But in this case the current will rise up by about 15% at full load. So if you will use the motor to drive any mechanical load take in your consideration the mechanical load Power (KW) must not exceed 85% of motor power (KW)
In India its 415V, 50Hz.
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
Depends on the current rating which should be on the motor.
No, the voltage of 500 volts is too high to operate a 380 volt motor.