I don't understand the purpose of that . Sounds bizarre !Please explain why anyone would even think of doing this.
No, Formica is harder.
We decided to cover our kitchen countertops with Formica for a more modern look.
PVC Cover Block is used in Construction to provide space for concrete during shuttering.
You use PVC glue or cement.It's really quite easy.First you clean the pvc with solvent,then you put on the pvc glue.You want a little more than will cover the joint,but not enought to drip.You hold it together for about a minute.Wait an hour before you run water through it.
On the valve cover
formica
you must first sand it so to remove any shiney surface then put a primer like bullseye then an all surface paint usually an alkyd or oil based
Melamine paint
its PCV and if it has one it should be right In the top of the valve cover, it should pull right out. then just put the new on in its place.
start the car and pull the PCV valve out of the valve cover and put your finger over the end of it and see if you feel it sucking.
The PVC valve on a 98 Eclipse is located on to or the valve cover. It is connected to the intake with a hose.
Pontiac PVC Valve is located on the Driver's side rear valve cover.