The adapter's voltage must match that of the device, and its current-rating must exceed that of the device. So the answer is yes.
Yes
No.If it is AC output, it will blow out the power circuits of the DC device.If it is DC output, it doesn't have enough current capacity for the load of the DC device.If you want to power a DC device with a wall wart, make sure the wart is:DC outputCorrect polarity (some have reversible polarity)Exact same voltage as the deviceGreater than or equal to current rating of the device
Using a 12v 600ma source is allowing 12 volts and 600 amps of power. If the device requires a 12v 500ma source, the larger source is acceptable. Please note that it will only be drawing on 500ma of the available 600ma.
Not for very long. If the device actually requires 2A in order to do its job, then the adapter ... which is only designed to deliver 0.5A or less ... will get warm, then overheat, and then fail. Possibly in as little as a few seconds.
i am not sure, BUT according to the answer in this post:Can_you_use_a_9V_600mA_adapter_on_a_9V_400ma_scanneryou need an adaptor of 9v and AT LEAST 500mA (assuming that the appliance draws 500mA)
If the camera actually uses 700 mA in order to do its job, then the 500 mA adaptor will warm up, then overheat, and eventually fail.
No.If it is AC output, it will blow out the power circuits of the DC device.If it is DC output, it doesn't have enough current capacity for the load of the DC device.If you want to power a DC device with a wall wart, make sure the wart is:DC outputCorrect polarity (some have reversible polarity)Exact same voltage as the deviceGreater than or equal to current rating of the device
Using a 12v 600ma source is allowing 12 volts and 600 amps of power. If the device requires a 12v 500ma source, the larger source is acceptable. Please note that it will only be drawing on 500ma of the available 600ma.
No, the new adapter will not be able to safely supply enough current.
A 12v AC adapter can be use to power devices that requires 12VDC and up to 500mA. It can also be use with electrical devices that require power but do not contain internal components to derive the required voltage and power from the main power.
Not for very long. If the device actually requires 2A in order to do its job, then the adapter ... which is only designed to deliver 0.5A or less ... will get warm, then overheat, and then fail. Possibly in as little as a few seconds.
Yes
You would overload and damage the device and/or the adapter.
i am not sure, BUT according to the answer in this post:Can_you_use_a_9V_600mA_adapter_on_a_9V_400ma_scanneryou need an adaptor of 9v and AT LEAST 500mA (assuming that the appliance draws 500mA)
I wouldn't recommend it ! If the device needs to draw more current than is available - the adapter could overheat, posing a fire risk.
It will take longer to charge the device
If the camera actually uses 700 mA in order to do its job, then the 500 mA adaptor will warm up, then overheat, and eventually fail.
No, if your device require 3.0A, 1500ma adapter which is 1.5A is not enough, voltage wise is fine, your adapter adapter will get warm, then overheat, then very likely fail.