If the camera actually uses 700 mA in order to do its job, then the
500 mA adaptor will warm up, then overheat, and eventually fail.
The adapter's voltage must match that of the device, and its current-rating must exceed that of the device. So the answer is yes.
No.If it is AC output, it will blow out the power circuits of the DC device.If it is DC output, it doesn't have enough current capacity for the load of the DC device.If you want to power a DC device with a wall wart, make sure the wart is:DC outputCorrect polarity (some have reversible polarity)Exact same voltage as the deviceGreater than or equal to current rating of the device
Not for very long. If the device actually requires 2A in order to do its job, then the adapter ... which is only designed to deliver 0.5A or less ... will get warm, then overheat, and then fail. Possibly in as little as a few seconds.
i am not sure, BUT according to the answer in this post:Can_you_use_a_9V_600mA_adapter_on_a_9V_400ma_scanneryou need an adaptor of 9v and AT LEAST 500mA (assuming that the appliance draws 500mA)
Yes, you can charge a 500mA battery with a 1300mA charger.
yes, if the other adapter is a va
Yes, a 9v 1100mA power adapter work with your 9v 500mA device. The mA number is the maximum amount of amperage that the adapter will produce without overloading itself. At 500 mA the adapter will only be working at half load.
Yes. As long as the voltage is the same which it is. The 800mA is the capacity that the transformer can produce safely without going into an overload state. Your original adapter was rated at 500mA which means that what ever device was plugged into it draws less that 500mA. You might notice that the new adapter is slightly physically larger. So you are safe to use the new adapter with the higher rating.
The adapter's voltage must match that of the device, and its current-rating must exceed that of the device. So the answer is yes.
Yes, no problem whatsoever as long as the voltages are the same. The adapter's capacity is 1000 mA and your device only requires 500 mA. The draw from the adapter is only at 50%.
No. There is a 50/50 chance it will work. Check the polarity on the label. Some adapters have the positive on the outside sleeve of the plug, others use the center portion. The device may be labeled, or use Google to locate the correct adapter for it. If you use a plug with the wrong polarity it might fry your device.
A one amp adapter is the same as a 1000 mA adapter. If your device requires 500 mA to operate then there is ample capacity in the adapter to operate a 500 mA device. Be sure to match the type of voltage AC or DC from the adapter to the driven device. Both have to be the same.
Yes you can. But it may damage your computers power supply.
No.If it is AC output, it will blow out the power circuits of the DC device.If it is DC output, it doesn't have enough current capacity for the load of the DC device.If you want to power a DC device with a wall wart, make sure the wart is:DC outputCorrect polarity (some have reversible polarity)Exact same voltage as the deviceGreater than or equal to current rating of the device
Not for very long. If the device actually requires 2A in order to do its job, then the adapter ... which is only designed to deliver 0.5A or less ... will get warm, then overheat, and then fail. Possibly in as little as a few seconds.
Yes. The current rating should be the same or greater than the original. This means the adapter can supply up to 500mA; In your case it only needs to supply 200mA, so it is more than up to the job.
No, you will burn out the camera. You can pick up the correct mini spy camera power adapters in the "Related links" section just below this box.