answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2017-12-29 12:14:51

No. The V6 in a 2005 Jeep Grand Cherokee was a 3.7L.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


average current is between 40 and 70 thousand. average life expectantcy is around 175,000


40 psi plus or minus 540 psi plus or minus 5



That code is a manufactureres code. You can type jeep diagnostic code p1494 into bing or google and get it to come up for you.


My two top picks would be 1: flowmaster 44's or 40's 2: glasspack


50 50 coolant is what i use- would suggest no more han a 60 40 mix.


Around 60-70 lbs cold, 35-40 lbs at normal operating temperture, and 15-30 lbs warm at idle.


Minimum spec at a warm idle is about 12psi. Normal is about 30 at idle. Should go 40-60 at 3000 rpm.


No. A 2011 Hemi requires 5W20 for the multi displacement system to function properly.



The exact cost to repair a blown head gasket on a Jeep Cherokee varies. It should run between 20 and 40 dollars.



Depends on your skills as a mechanic, your tools, and the problem. Some of them you have to Chad in all honesty NO. well you can if you want to pay an extra 40% any private shop can work on a jeep Cherokee


Check the tires for an out of balance issue. Check the u joints in the rear shaft.


A full operating temperature it will be around 40 psi.


Engine Coolant is probably coming out of a small hole on the bottom of your water pump. This usually means your seals are gone in the pump and that the pump should be replaced. This happened to my '93 Jeep Grand Cherokee on I-40 near Knoxville about 3 years ago. NEW ADDITION: I am having the same problem with my 94 grand Cherokee today, we replaced the water pump and the problem still persists, there may be a hole in the radiator like mine.. just replace the radiator.. that's what im doing


40 psi is about right Check the sticker in the drivers door jamb.


The Jeep Cherokee 4.0 liter engine cylinder had torque specifications are 120 pounds per square inch. The cylinder head bolts should be torqued at 40 pound intervals.


Around 30-40 psi when at full operating temperature. Can even be somewhat lower on a high mileage engine.


Castroil 10w 40..They also make a high millage oil, is great if you have over 1000,000 miles.



Have you changed your oil lately? You can try adding 10/40 wt. oil the next time you change oil.


The users manual stats that the oil pressure at idle should be 13 lbs minimum and between 40-60 at hiway speeds


Try spraying some WD-40 on it. PB Blaster works great also, Mike


it is your bearings or "hubs" that happened to mine my jeep would shake so bad i had to stop then i replaced both and it was gone.....You can get them on eBay for like $50 don't buy them from the store it will cost like $150



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.