The oil pressure switch on a 1996 Chevrolet Cavalier is on the rear of the engine block. It will be directly above the oil pan.
The coil pack, on a 1996 Chevrolet Cavalier, is located on the top of the engine. The coil pack is near the electronic spark distributor.
It should fit if both cars had that engine from the factory. If the 1996 was a Z24 (2.4L), then there will be differences - most likely with engine electronics. Hope this helps!
The 1996 Chevrolet Cavalier headlight module can be found on the firewall, in the engine compartment. The module will be on the drivers side of the firewall.
On your 1996 Chevrolet Cavalier 2.2L SFI OHV , the Oil Pressure Switch is located: Under hood, center, front engine area, next to transmission bellhousing, mounted on engine block.
Your 1996 Chevrolet Cavalier 2.2 liter engine oil pressure should be approximately 40 psi. A range of 35 to 45 psi is acceptable.
If a 1996 Chevrolet Cavalier will not start, it could very well be the fuel pump. It could also be the starter or battery.
no way i tryed that swap and didnt work ecu computer changed
1996 Chevrolet cavalier shuts off while driving and have to put in natural or park to restart
i don't see why not the 2.2 was used in 95 and 96 should fit right in
The 1996 Chevrolet Cavalier 2.2 liter engine had bolt torque specifications are 120 pounds. The head bolts should be torqued at 40 pound intervals.
Apparently, there is none. They started using them in 1996.
Both the 2.2 and 2.4 liter four cylinder engines in a 1996 Chevrolet Cavalier use a timing CHAIN
yes it will
Under right front seat
No....The engine mounts are in the wrong place.
under the front bumper fascia.
change coil module
check this site out
No...No....No... The 2.2L OHV engine and the 2.4L DOHC (Quad-4) engine are two different animals.
Chevrolet does not use inertia/reset switches.
4 quarts with oil filter