Yes it can. The pressure can get backed up into the vacuum areas of the motor and cause back pressure. The PVC valve will eventually get clogged so it it a good idea to change out the PVC valve at least once a year. It is a relatively cheap part and replacing it is definitely a DYI project. Should only take a few minutes.
Note* Be Careful with the Hose it is attached to. It may be old and could crack. If it does it can be replaced with automotive hosing that can be bought at any automotive store. Should be only a few bucks. If it is dried and cracked definitely replace it. Once again a DYI project that should take only a few minutes.
Hope this helps.
It is very important to change PCV valve. If valve is old it will plug or seize. This will cause oil pressure to rise and may cause leaks. Most likely the valve cover gaskets will leak if PCV valve is plugged.
A bad PCV valve can cause the engine to smoke. The valve is easy to change in most engines to correct the problem.
No, the only thing a dirty PCV valve will cause is a build-up of gas pressure inside the engine which make seals and gaskets fail.
yes. if the valve is plugged or stuck closed, oil can be sucked into the intake through the pcv breather.
If the vacuum hose connected to the PCV valve was disconnected, it would idle poorly if at all, otherwise, no.
Positive Crankcase Ventilation (PCV). The PCV valve acts as a vent to the upper engine removing excess combustion gases via vacuum lines that plug into the valve. A dirty or restricted pcv valve and cause excess pressure on internal oil seals and gaskets.
Pull upward on the hose that the PCV valve is in. The PCV valve will pull out of the hose. The PCV valve is located in the valve cover.
NO it would not.
Bad PCV valve.
Stuck or bad PCV valve on the Valve Cover to the carb or throttle body. The other is the EGR valve. Most likely the PCV.
Disconnect the PCV valve tube from the PCV valve.Disconnect the PCV valve electrical connector if it has one.Turn the PCV valve counterclockwise to remove from the valve cover.To install, reverse the removal procedure.
oil leak and poor gas milage