0
Can a bad fuel filter cause the gas gauge to fail in Pontiac Aztek?
Wiki User
∙ 16y ago
The Aztek has been known to have screwy gas gauges. Mine "floats" from E to F and sometimes shows the actual level. I've heard it's a bad sending unit in the tank causing the problem. If your gauge just lies there, it's probably that the sending unit is done.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the fuel gauge sensor on a Pontiac aztek?
it's located in the fuel tank on the fuel pump
Why would the temp gauge show hot even though its not on a 2001 Pontiac Aztek changed thermostat intake gasket and temp sensor?
thermostat may be sticking and that cause the gauge to show hot, have it checked soon, you could be headed for bigger problems
What would cause the temperature gauge not to work on your 1998 Pontiac Sunfire?
temperature gauge not working can be caused by a bad temp sensor in engine, a bad gauge in dash, or a bad fuse
Where is the oil sender on 1995 Pontiac Trans Am?
My oil pressure gauge is dropping to o and the oil was just changed and is full. What could cause this
How do you fix the oil pressure gauge in a 2005 Pontiac Bonneville?
Go to a Pontiac Mechanic and spend a few bucks.
Why does the temperature gauge in your 2004 Pontiac grand prix fluctuates so much?
Because it is a Pontiac. Sorry, man.
What would cause a 2001 Pontiac Grand Am's engine temperature gauge to not work?
Coolant Temperature Sensor
What do the gauges near the filter indicate?
The gauge near the filter of the pool will tell you when the filter needs cleaning, the higher the gauge reads the more backpressure is caused by dirt in the filter, most gauges have a red section that indicate the need to clean the filter.
What is an indication that a sand filter needs to be backwash?
The pressure gauge will generally read 10 PSI higher than when the filter was clean. In any case do not let the filter gauge go above 40PSI.
Why is the oil gauge in your 1991 Pontiac le sunbird always at its peek?
Check with manual gauge - if pressure normal - could be defevtive oil pressure sensor or gauge
Is it possible to have a Pontiac sunfire without a rpm gauge?
Yes, special order.
What to do if the sand filter gauge reads zero and won't backwash?
this usually means that the multiport valve in the filter head is bad.. the gauge is not always accurate. replace gauge. the impeller in the pump can also be cloged not allowing you to get any pressure in your gauge. the backwash will be very slow if not any..
