3-3-09 The fiero gas tank is under the center of car. You will need to remove four 1/2 inch or 13mm bolts that hold the protective plate. There are two straps that hold the tank up. One in the front and one in the rear. The bolts for those straps are up in between the tank and body on the drivers side. you will need a 13mm deep well socket for these. Once those are removed and pushed out of the way., go to the rear of the tank and remove the fill hoses using a 5/16 socket on the hose clamps. should be a couple of 1/4 inch clamps on the pump lines as well and may need to disconnect directly from fuel filter depending on year and engine. After all of this you also need to remember to unplug the pump wires which can be accessed from above in the engine compartment. They will be located in the center of the car along the firewall. There are three wires brown, pink, black usually all in one connector. After fishing these wires down you will be able to move out the tank and change pump. Hint on installation. Use wd-40 and spray on fill hoses to ease reinstalling
Pontiac Fiero was created in 1984.
How do you replace the alternator on a 1988 Pontiac Fiero
what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder what is the smog and vaccum diagram for the 87 Pontiac fiero 2.5L 4 cylinder
Yes, sort of, The clutch is different.
what is the fuel pressure on a 1987 fiero gt
Yes I can
NO
No.
It is a RWD
There is someone with a Olds 455 in his Fiero, but he had to remove the trunk.
1984
what about them?