Want this question answered?
have the heaters check, i had the same problem but fixed when changed heaters.
5G is a welding position for pipe. The pipe is in a fixed, horizontal position. There is a groove along the circumference of the pipe where the weld is to be made.
Copper chloride is a compound, with a fixed atomic ratio between copper and chlorine.
no, DOT do not allow welding to be done to repair a wheel
Usually a radiator is made of metal. Plastic can not take the pressure. A hole can be fixed by welding. A radiator shop can tell you for sure.
For firing current between the the moving arm of the gun and the fixed arm
It is probably aluminum and depending on where and how it broke, it can be heli arced which is welding aluminum.
Copper has 29 electrons and protons; the number of neutrons is specific for each isotope. Number of neutrons in a copper isotope = Mass number - 29
I'm just concluding a work in which I had to design a shell and tube exchanger for condensation of a mixture of gases and vapor at low pressure. That was the type I chose. AEM is a type of shell and tube heat exchanger, according to TEMA standards. They use 3 letters to describe the configuration of the heat exchanger. First letter refers to the front head, second letter to the shell type and third letter to the rear end stationary head. So in this case, with a type A you would have: A for channel and easily removable cover. E as it is a one pass shell and M because you have a fixed tubesheet with a rear end in bonnet shape.
Copper atoms vibrate around fixed together, whereas Mercury atoms more around while staying close together- NovaNet
Either something is a metal, and is therefore metallic, or it is not. The terms are fixed.
A dx or direct expansion coil describes a type of heat exchanger. (As compared to chilled water.) The tx valve regulates the refrigerant. Systems without a txv will have a fixed orifice. The txv is generally more efficient than a fixed orifice.