No
u have a slave cylinder bolted on the side of the transmission,check to see if it is leaking,if it is ,replace and bleed,if not leaking .check your clutch master cylinder to see if its low, if not ,then u may need anew clutch.
There is a smaller master cylinder next to the brake master cylinder. The clutch uses brake fluid also. If you mean where does it go if it is low, the slave cylinder on the transmission is probably leaking.
The clutch master cylinder is in the engine compartment and the slave cylinder for the hydraulic clutch is inside the manual transmission bellhousing
The clutch master cylinder is in your engine compartment , the hydraulic clutch slave cylinder is inside your manual transmission bell housing
if your talking about the transmission dipstick...there isn't one on a manual transmission vehicle...you check the clutch master cylinder, it's just like the master cylinder for the brakes, but for the clutch...if it's low you can use DOT 3 brake fluid, or hydraulic clutch fluid
Its hydraulic ,you cant,check your slave cylinder to see if its leaking,its located thru a rubber cover on side of transmission,if leaking replace and bleed,also check clutch master cylinder,if not leaking,then you might need a new clutch kit.
The fluid is leaking from the master cylinder and running back towad the pedal. Replace the master cylinderanswerchange master cylinder and slave properly then bleed the system properly.
Master cylinder is leaqking internally, what fluid is leaking and can I add fld. until it is repaired ?
The gasket to your clutch master cylinder is probably broken or cracked. or your master cylinder is bad.
Go to the transmission and check slave cylinder for leaks,also check clutch master cylinder,then go look by your clutch pedal to see if its leaking there,these are your places that it could be leaking,is your fluid level low,if not ,then you may need a new clutch kit.
Look for leaking fluid at the slave or master cylinder.
The clutch slave cylinder is probably at fault. Replacement is necessary to fix problem. Transmission must be removed to gain access to the slave cylinder.