0
When a low pass filter is used with a sine wave input, the output is also a sine wave. The output will be reduced in amplitude and phase shifted when the frequency is high, but it is still a sine wave. This is not the case for square or triangular wave inputs. For non-sinusoidal inputs the circuit is called an integrator.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is Gaussian low pass filter?
Gaussian low pass filter is a image smoothing filter which is used to smooth up a digital image...........
What is the lowest frequency of an LC low-pass filter?
The lowest frequency of an LC low-pass filter is zero, i.e. DC.
What is a wide Band-pass filter?
A: This is term used to describe a filter that has wide or a big range of frequency available to pass trough. There are others name to describe other ranges of frequency like low pass, hi pass, narrow pass.
Can you use inductor in low pass filter?
Type your answer here..yes.
What should I do to install a low pass filter if my amp doesnt have one?
A: Installing a low pass filter is only required if the frequency are not there or to eliminate the low frequency, If it is an audio amplifier you never will need low frequency since your mine hears cannot hear those frequency.
Why high pass circuit is called as an Differentiator?
That is its function. An RC low pass circuit is an integrator.
What is Gaussian low pass filter?
Gaussian low pass filter is a image smoothing filter which is used to smooth up a digital image...........
What is a low pass filter?
A low pass filter allows "low" frequencies to pass through a circuit and blocks higher frequencies.
Is earth high pass filter or low pass filter?
Earth is low pass filter, because it tends to absorbe the amblitude of the high frequency waves.
Is a first order low pass filter a lti system?
low pass or high pass
Why does low pass RC circuit filter the voltage?
In a DC power supply, a low-pass RC filter is typically used to "filter the voltage" by reducing or eliminating any remaining ripple. This works because such ripple has frequency components over 0 Hz (ripple is essentially an AC component with an offset), which are suppressed by the low-pass filter.
How do you use series RLC circuit as band pass filter?
by combining a low-pass filter with a high-pass filter.[1]
What different between high pass filter and low pass filter?
A low pass removes frequencies ABOVE a set level. A high pass removes frequencies BELOW a set level. A separate high pass filter can be used to route only frequencies over, say, 80 Hz to your main speakers (if your receiver/processor did not have this function). Then you would set the low pass filter on the subwoofer to 80 Hz to reject signal above that level.
What is the lowest frequency of an LC low-pass filter?
The lowest frequency of an LC low-pass filter is zero, i.e. DC.
What is another name for a low pass filter?
Butterworth filter
What is band pass filter?
A: This is term used to describe a filter that has wide or a big range of frequency available to pass trough. There are others name to describe other ranges of frequency like low pass, hi pass, narrow pass.
What stage of the receiver demodulates or removes the carrier waves from the audio waves?
Answer: In some demodulaters like synchronous detector carrier is multiplied. then obtained wave form is passed through low pass filter. here carrier is removed In some demodultors such as square law detector non linear device is used and there after low pass filter is used. At low pass filter carrier is filtered
