0
Can a rear engine seal be replaced on dodge ram 5.2 without dropping crank and is it one piece or two?
Wiki User
∙ 10y ago
It is two piece, and can be changed in vehicle.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
Ford escort diesel has had injector pump replaced Engine will not crank?
will need recoding
What causes a 99 Alero to stall on ignition when the engine is warm?
The crank sensor probably needs to be replaced.
Can you bypass the crank sensor on 97 jeep charokee?
The crank sensor is an important part of the engine wiring. Without it the engine does not know when to fire. There is no way to by pass it.
Your 1997 Camaro will crank but not fire?
Low battery - not enough power to crank all the way over or, Fuel pump needs to be replaced, not getting fuel into the engine.
Can you replace the main crank bearings by dropping the oil pan?
yes
How do you start a car without using prepositions?
Push the starter. Crank the engine. Turn the key.
Can you change your crank shaft in your 99 dodge 1500 5.9 magnum without pulling the engine?
No.
Why is your timing belt shredding?
abuse, not keep your car maintained. it can blow an engine. If the belt was replaced and then began shredding, the shim washer on the crank may have been installed between the lower crank gear and the block. The shim washer should be between the the crank gear and the crank pulley.
How do you know if a crank sensor is bad on a 6.0 powerstroke?
6.0 powerstroke had crank case sensor replaced by a dealership. 24hrs of runtime and engine refuses to start again. what happened to owning a reliable diesel??
What is involved in fixing a spun rod bearing?
The easiest repair is to replace the engine. Otherwise the crank shaft will need replaced/remachined and the connecting rod will need replaced. Basically a complete overhaul.
Will a Crank position sensor make a engine not crank?
No, it will crank, but it will not start.
1987 300zx stoped while driving will not start cranks a little then starter hiss no engine crank starter replaced same problem?
you might have blow out a head or over headed the engine
