0
Yes it can. I had a 1998 Honda Odyssey with an aftermarket set-up and it did that. I would pull over, put it park and restart. After an ignition switch recall, the system is not connected anymore so the problem is gone.
Wiki User
∙ 15y ago
Wiki User
∙ 12y agoNo it does not.
Add your answer:
Earn +20 pts
Will repeated unsuccessful attempts to start car cause engine damage?
Repeated attempts to start a car will not hurt a car as long as the engine has the oil it's supposed to have. However, they aren't good for the battery.
When do you know when you have played too much Tetris?
When your eyes start to hurt and you play a long time. EX. 10:00pm to 4:00 am
Where to find and how to replace the starter on a Taurus - Sable?
What does a starter cost? 1998 DOHC: Autozone has two offerings: $135 for a re-manufactured unit and $155 for brand newWhat about the starter solenoid? The starter solenoid is integrated into the body of the starter, and cannot be replaced separately. You will need to replace the entire starter assembly.New Answer It is simple to replace. They are located at the front of engine.Disconnect Negative Battery cable first,raise vehicle and support vehicle,remove the electrical wires from starter,remove mounting bolts (2 or 3) and remove starter.I know this because I used to work on them. Answer Remove - battery cable Raise and support vehicleDisconnect wiring harness at top of starterRemove starter mounting boltsRemove starter Where to find the starter the easiest way to find the starter on any vehicle is to follow the wire directly from the battery down to the starter, it may go from the battery to a junction post used for jump-starting, but it will go from there to the starter because you need a direct flow of current from the battery to turn the starter over. Starters are typically found at the front - bottom of the engine.Note that the front end of the starter inserts into the place where the transmission and engine join up, so look in the middle section At the end of the rad battery cable coming off the battery. Answer Disconnect Battery First It's simple. 2 bolts, two wires. Raise the front of the car, put jackstands underneath. Crawl under the front, look up, there is the starter. Remove the two wires, note their positions, one is big, the other is small. Remove the two bolts, remove the starter, be careful not to let it drop on your head, it might hurt. Replace the install the two bolts, install the two wires(they will only go on one way). Lower the car, reconnect the battery, and Voila! 30 minutes later, you are done! Go get an ice cream or a soda, you deserve a reward! Remove one post from battery then wire connections from starter. Remove mounting bolts and remove starter. Towards the front of the car about a foot back from the radiator bolted to the engine/trans.; it is accessible from underneath.Sable Starter The starter on a 96 Sable with a 3.0 litre is at the front of the engine (looking down on the engine compartment with the hood open standing at the front of the car) where th engine and transaxle bolt together.To lay down under the bumper and looking up is the best way to view. Answer It's simple. 2 bolts, two wires. Raise the front of the car, put jackstands underneath. Crawl under the front, look up, there is the starter. Remove the two wires, note their positions, one is big, the other is small. Remove the two bolts, remove the starter, be careful not to let it drop on your head, it might hurt. Replace the install the two bolts, install the two wires(they will only go on one way). Lower the car, reconnect the battery, and Voila! 30 minutes later, you are done! Go get an ice cream or a soda, you deserve a reward! Answer Disconnect the battery, raise the front end and crawl under the car. The starter is bolted to the transmission bellhousing, and will be held on with either 2 or 3 bolts. There will be two wires going to the starter, one held on with a 13mm nut, the other held on with either an 8mm or a 10mm nut, or it may have a small spade type connector. There will also be a ground wire attached to one of the starter bolts with a nut. Disconnect the two wires and the ground wire, unbolt the starer, and replace. It is noyt difficult, and it will probably take you about 30 mins to do, once you figure our what tools you need, which you should be able to do everything with a basic socket set, as long as you have some deep well sockets. Answer It's simple. 2 bolts, two wires. Raise the front of the car, put jackstands underneath. Crawl under the front, look up, there is the starter. Remove the two wires, note their positions, one is big, the other is small. Remove the two bolts, remove the starter, be careful not to let it drop on your head, it might hurt. Replace the starter, install the two bolts, install the two wires(they will only go on one way). Lower the car, reconnect the battery, and Voila! 30 minutes later, you are done! Go get an ice cream or a soda, you deserve a reward! Answer The solenoid is part of the starter. Replace the entire starter. It is located next to the oil filter at the front of the motor. Follow the positive battery cable; it will first lead to the starter solenoid and then continue to the starter.Disconnect the - battery cable Raise and support vehicle Remove wiring from top of starter Remove starter mounting bolts Remove starterAnswer - 1992 remove + battery cable remove starter, I used a 3 foot extension to get to the one nasty bolt in back, put just in front of the left front tire..sometimes it pays not to get too close to your work!! Its not hard, but access to bolts are terrible. It look simple till you try and get a socket or wrench on the nut/bolt!! install new starter, hookup wires at starter, then battery+. crank, crank, zoom,zoom [with the 3.8] Inspect for damaged wiring in the harness for the starter. Sharp corners can cut..Depends what year is it, on a 1998 it's at the bottom by the oil pan and there are three boltsThe starter is located just underneath the oil filter.This is a fairly simple repair. You will need a socket set (you can do it with wrenches if you have to, but sockets make it much easier) and a jack.1. Disconnect the negative terminal from the battery.2. The starter is located directly below the oil filter. It is held on by two bolts which are to the right of the oil filter. One is easiest reached from the top of the car and the other from the bottom. If you have trouble locating the bolts, just take a look at your new starter to determine where the bolts are located. The bolts screw in from the driver's side of the car.3. Once the bolts are off, the starter should be loose from the engine. (You can thank the designers at Ford for making this a particularly dirty job. The starter gets doused with oil every time the oil filter is taken off so get you can expect the bolts and the starter to be covered in grease and gunk.)4. Maneuver the starter so that the terminals facing up so you can easily get to them from the top of the engine compartment. Pull the terminal cover off. Remove both cables from the starter. The starter should now be completely free.5. Place the cables on your new starter and replace the terminal cover. Bolt the starter back in same position as the old one.6. Reconnect the negative battery terminal and start the car.Remove the Negative(black) wire off the battery Raise and support the car. using a 10mm wrench remove the smaller cable going to the starter. using a 13mm wench/socket remove the larger cable that comes strait from the Positive (Red) terminal of the battery from the Starter using a 13 mm wench remove the lower and upper starter bolts. The heads for these are on the engine side of the starter. They will likely be hard to turn at first.the starter should now be easy to remove. Compare the old and new starter to make sure they match, then do the above steps in reverse.
How do you replace a car starter on a 1981 Chevrolet El Camino?
if your wiring from scratch the original vettes had a positive battery cable on the main bigger terminal on the starter solenoid. they woul also have fusable links that feed certain circuits power when ignition like lights horn auto locks brake lights. the s terminal is the signal from the ignition swich that would engage starter when key was turned all the way, the start wire from ignition switch is wired through a safety circuit, for manual transthe circuit is open until clutch pedal is depressed with auto trans its wired through the neutral safety switch. the reson for this is so when you try to start your car in gear it will not engage starter until clutch padel is depressed, with auto if car is left in any gear except park or neutral the starter will not engage. I have seen many people hurt running direct feed to starter. they turn the key and the carlurches instantly into whatever is in your way. do it right
Do tattoes hurt?
It really depends on where on your body you get your tattoo
Will a remote starter hurt your car?
No.
Does paintball hurt cars?
well if you shoot the cars....
What are facts about cars?
cars don't help the earth the hurt earth and they hurt people
Will a magnet hurt your wii remote?
I do not know...BUT DO NOT TRY ANYWAYS!
Will the remote car starters hurt your car?
No effect, at all.
Can you add a remote starter to a 2011 Hyundai Sonata?
Yes, you can. I advise getting it done with your dealer because they know all the ins and outs of the push button start and will better aid you in knowing how to use the remote start properly with the new technology. Getting it done with them will not hurt your warranty if they mess anything up. I bought one 3 months ago and just had the remote start installed after Christmas and love it. Very convenient especially if you're in a cold area. You can also have other features programmed i.e. garage door open, window roll down, rear defrost turn on, etc. Inquire with you dealer they should offer about 4 different packages. Hope this helps
What is the top speed in NASCAR racing?
When the cars start hitting 200 mph., NASCAR slows them down with restrictor plates. Above about 200, bad things happen, like cars crash, and go over fences and hurt spectators.
How do cars hurt the environment?
Cars hurt the environment because gas takes oxygen from trees. Also cars take gas. If trees are dieing, we have no oxygen to breathe in, and we may be caused by sudden death. That is why some people make car polls. I don't like to take the car but my guardian always allows it. I like to ride bikes but now it is the winter time. Cars make pollution. That is why cars hurt the environment.
How do you bypass the starter so that you can start the vehicle even if the starters no good I tried hookin up boster cables to go direct and it started turning over like crazy. Did I mess it up bad?
You may not have hurt anything. The starter will spin as long as the cable is sending power to it. The ignition switch needs to be turned on to make this work. Touch the jumper cable to the starter connection. The starter will spin and start the engine, assuming that there are no engine problems. This is a dangerous move, because if the car moves or it is in drive, then the car will drive over you.
How did the invention of the steamboat hurt?
fat greese was used to build cars
How did technology improve for cars?
it helped them so they don't hurt the environment
How do you no when you will start your period?
you can get cramps or your stomach will hurt or your feet can hurt too but you can never be sure about when u start your period
