== An electrical engineer would not recommend you to try to use in Europe such a high voltage piece of equipment that was designed for use in the US. One reason is that, if the machine uses an electric motor, the lower frequency of the mains supply in Europe, 50 Hz (50 cycles per second), may make the motor run too slowly compared to the speed it was designed to run at in the US, where the mains frequency is 60 Hz. The answer given below mentions an "adapter" but such things are only appropriate for use with low energy appliances such as chargers for cellphones, shavers/razors, etc. Small adapters are fine to use to convert the mains supply from 120 volts to 230 volts, or vice versa, at relatively low levels of power. Something which runs at 460 volts is not at all the same kind of application! In an area where the mains supply is delivered at 50 Hz it is much safer only to use equipment which has been designed to run on 50 Hz. OK, maybe you could use a transformer to increase the voltage but it would not be good practice to do so. Indeed, such a transformer, which should only be used if safely housed in a protective casing, might cost as much to buy - new or secondhand - as a machine that has been correctly designed to do the job using the standard European mains voltage and frequency. == Maybe you should get a different type of adapter. There are adapters available which increase or decrease the voltage respectively as conventionally used by you all in Europe.
The machine will be designed for a range of voltages which might include 400 v and 460 v but it depends on each individual piece of equipment. You should be able to read the voltage range on the piece of equipment.
Depends. Some smaller stuff can usually run on both, in which case it will be printed on them. If it isn't, you can't run a 220v item on 110v.
no way because frequency cannot change
The internal working of the motor is designed for 110V/60Hz. Your stepdown converter is from 220V/50Hz to 110V/50Hz. Frequency converters from 50Hz to 60Hz are very expensive (many times the cost of a new clipper). Therefore it is better you get a clipper designed for 220V/50Hz. If you still like to put your clipper to use, then the most cost effective solution would be to get a "car inverter" that would convert 12V DC to 110V/60Hz AC.
You can but it would be wise not to. Most 60hz appliances will not work at 50 Hz. <<>> Yes, no problem at all. The frequency does not enter into the equation because the hot plate is a strictly resistive load.
Not really because motors are designed to run at either 50 or 60 Hz and the wrong frequency might cause them to malfunction or overheat.
you can't
Yes, no problem.
nothing
No! Normally not, the recistance in the windings is to hig on 60Hz and the pump motor has not power enough to work propelly. This happened to myself when I connected my Whirpool AWE 7519 to 230V 60Hz. Europian model for 50Hz.
No, 120 v is not enough.
No
Yes no problem the transformer should run a little cooler as well.
Yes, using a 220v-60hz microwave in Australia is fine. The voltage of alternating current supplied to homes in Australia is 220v. The frequency of the voltage is 50hz.
More than likely yes it will work just fine.
yes.
No. For more information see the answers to the Related Questions shown below.
Yes, purchase a step-down transformer.