No, it can't .
after all spray is dried up!! engine will stop smoking after excess paint on engine has been burned off
Normally, you cant. The best thing to do is take a new can of spray paint and replace the spray tip. The tip is commonly clogged because most people dont invert the can and clear the tip of old paint from the last use. The old paint dries up in the tip and the can doesnt have enough pressure to remove the dried paint. When you are done using a spray paint can, turn it upside down and spray until nothing but air comes out. 1-2 seconds should do it. This will ensure it will work the next time you use the can.
It beads up and doesn't dry. It you touch it it will wipe off. It may leave a faint stain, but it won't show up strongly. If you put wax on spray paint then it will make it hard to remove the spray paint and it will also make the spray paint look glossier.
no it does not
To effectively touch up spray paint using a brush, first ensure the spray paint is fully dry. Then, lightly sand the area to be touched up and apply the paint with a small brush using smooth, even strokes. Allow the paint to dry completely before applying additional coats if needed.
I recently had a ceiling sprayed and the foam got on everything. Since we are building, I needed to get the foam off of the studs. I used a paint scraper and it worked perfectly. You can pick up a scraper at any store that sells paint. Hope this helps.
you take the paint and put it on the end of the bike first and work your way up !
Spray cans are filled by weight and not volume and it would depend on the size of the spray can, but it should take about four to five 12 oz net weight cans of spray paint to equal approx a quart of paint. How much makes it on the project and how much ends up as over spray depends on the painter.
it jams up
To touch up spray paint for a seamless finish, lightly sand the area, apply thin coats of paint, and blend the edges with the surrounding surface. Allow each coat to dry before applying the next one for a smooth and even finish.
Most computer designers are just simple colour but some really complex. If I was you, I would probs spray paint it all in a dark colour and spray paint my name in (or use clear sticky paper. But its all up to you.
Paint is pushed through a spray head, either by air, hydraulically or by gravity feed. As it goes through the spray head orifice, it is broken up into small particles that are small enough to either be pushed onto the painting surface by air or in the case of an airless spray, formed into a fan shape by the spray tip.