Want this question answered?
Disconnect each shut off valve then blow through the pipe with a compressor - then drain and clean the tank, this should be done every 4-5 years to avoid this problem.
in the plumbing world nitrogen is used for purging the air, O2, out of medical gas lines or refrigeration lines for air conditioners. nitrogen is used because it does not burn like O2 thus leaving the inside of the pipe clean.
•Vertical lines are pH species •Horizontal lines describe redox changes •pH and redox are diagonal lines
The lines show where a phase changes happens to a substance -
a table formatted with horizontal lines is called
I am an old style mechanic. Heater cores are made of copper or aluminun & Plastic. Muriatic acid will eat any heater core up and cause leaks. Cut it out of the loop and connect the lines together. Get it replaced, a major and expensive job. Sorry about that and good luck.
The cast of Clean Lines - 1978 includes: Al Byrne as Himself - Presenter
Anyone can clean draft lines. Proper training is required as somewhat hazardous chemicals are used to flush the lines.
You don't, you replace them.
Flush the lines from a clean potable water supply
Bath Crashers - 2010 Clean Lines and Concrete 3-3 was released on: USA: May 2011
Flush them through with a solution of sodium meta-bisulphate, followed by clean water.
With a water Jetter which will scour the lines to restore full flow
the nitrogen is only used to clean out the lines prior to adding the refrigerant
McDonald's use the sanitizer brand purell.
Try chemical in fuel tank available at auto parts
Disconnect the fuel lines and use berrymans spray to clean the pit cock.