0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What would cause the temp gauge to bottom out and stay in that position and the fan on the motor to run constantly?
The thermometer that reads your engine temperature, I presume, is damaged or broken. Without the gauge to tell your fan how hot your engine is it will keep running as a 'better be safe then sorry' feature.
Is there something wrong with your charging system if your alternator gauge reads that it's charging all the time?
Check with a voltmeter A fully charged battery should read approx. 12.8 volts without engine running Should read approx. 13.8-142. volts with engine running if higher than this probably a bad voltage regulator
Engine management light has come on a vw golf 2012 2.0 diesel?
To troubleshoot an engine management light on a VW Golf a diagnostic light is recommended. The test will display any malfunction codes it reads from the engine computer.
How do you test an alternator while the engine is running without having to remove it from the car?
Put a voltmeter on the battery.If it reads 12 volts or less,the alternator is not charging.It should read 13 or 14 volts.Make surte your belt is not loose or broken also.
How do you fill transmission in 73 dodge coronet 318 engine?
you fill it through the dipstick tube, get a funnel and pour away until the dipstick reads full with the engine in park and warmed up and running.
What does a car decoder do?
Reads error codes from the car's comp.
How do you read fault codes on 1996 Toyota starlet sportif?
Jumper wire between te1 and e1 terminals ,binary code reads out as flashes on engine fault light.
What does it mean when the battery light showes on the dashboard of a rover 25?
Alternator may not be charging battery properly Check with a volt meter With a fully charged battery and engine not running reading should be around 12.8 volts With engine running reads should be 13.8-14.2 volts
How many quarts of motor oil does a 1987 Chevy El Camino take?
The V8 holds 4 quarts, 5 quarts with oil change. The V6 holds 4 quarts, with or without filter change. Owner's manual reads to check level after running engine.
How do you us OBD2?
An OBD2 code reader is used by locating the connector under the dash and attaching it to the vehicle. It then reads the diagnostic codes of the engine which can be read or deleted using the control pad.
What device reads codes and allowed you to hear a CD?
A laser head.
Why would the service engine soon light come on in a 2004 Trailblazer?
There are too many codes to list. You must get the code read at a service center to figure out what the problem is. The single most important thing to remember is that if a check engine light is flashing you must shut the vehicle down immediatley.Autozone reads codes for free.
