Want this question answered?
Typically, the hammer strikes the firing pin which may fire a round, if there is a fresh round in the chamber. In older pistols, the hammer can hit the primer directly (the tip of the hammer has the firing pin on the end).
No. First- let's be clear about this. The bullet is just the piece of lead that shoots out the barrel. The bullet + brass casing + gun powder + primer is called a CARTRIDGE. A dysfunctional cartridge is called either a dud or a mis-fire. It is bad for the gun when you go through the motions of firing the weapon without a cartridge actually being in the chamber. It causes unwanted wear and metal fatigue on the hammer and firing pin assembly. A snapping cap (sometimes called a snap or snapper cap) has the same dimensions as a cartridge but has no primer, no gunpowder, and no bullet. It is a true dummy cartridge...one that you place in the gun's chamber so that you can "fire" the gun without harming it.
A firing pin that is mounted on/in a hammer
In older guns....and most guns that people think of when they think of a handgun or rifle, there is a "hammer" and a "firing pin". When the trigger is pulled, the hammer is released and it strikes the firing pin which in turn strikes the primer on the cartridge, firing the round in the chamber. With a striker fired gun, there is no hammer. The striker, which is basically a spring loaded firing pin, is released, doing the job of the firing pin and hitting the primer on the round in the chamber. These guns have become very common, and you will find examples of a striker fired system in all Glocks, Springfield XD's, S&W M&P's, Taurus 24/7, etc.
load one bullet, then put rolled up dollar bill, then load other four bullets...then cock hammer...letting come to rest...if done properly, hammer is now resting on empty chamber...they say it was a place to safely keep a billfold and to remind one to rest hammer on empty chamber...
The basics: you activate the trigger, the hammer strikes the firing pin, the firing pin strikes the primer on the cartridge, the bullet is propelled down the barrel and goes to wherever the sights were aimed the instant the shot broke.
When The Percussion Cap That The Hammer Hits Ignites The Gun Powder, The Powder Turns Into A Gas Which Expands In The Chamber Of The Gun Sending The Bullet At A Very High Rate Out The Barrel.
The firing of a bullet is caused by a chemical reaction which occurs when the powder contained within the cartridge ignites, causing the formation of gases which expand and push the projectile out of the casing and down the barrel. This reaction is started when either the rim or the primer of the cartridge is struck by either a hammer, striker, or firing pin (depending on what action the firearm has). The hammer or striker is set into motion by a spring which is compressed until a sear is moved to release the hammer or striker (a hammer may either contact the primer directly, or it may hit a firing pin, which in turn hits the primer). And the sear is released by pulling on the trigger.
No. That cartridge is actually a practice round for dry firing a weapon (people use them to practice with the action of a gun without harming the hammer)
Handguns work by having some mechanism hit a sensitive primer to initiate a control deflagration and shoot a bullet. If a handgun doesn't have an external hammer that either strikes a firing pin or the primer directly, it will have an internal hammer--called a striker.
The basic concept of a conventional firearm is a round or bullet is loaded into the chamber and is then struck by a small hammer as the trigger is pulled from the inside rear end of the chamber which then causes a chemical reaction inside the round with gunpowder and maybe some other one not sure and thus causes the projectile tip to propel forward at extreme velocities and as the tip leaves the barrel it leaves behind a casing which can be ejected either automatically or manually by hand; Firing speed, FPS, etc. all depend on the firing mechanism used by that particular gun. ;)
Install a water hammer arrestor (air chamber)