Yes. The idea is usually to add it to the old oil and then flush it out with the oil change. Read and follow the instructions for the product you are using.
Using your owner's manual or your eyeballs, locate your radiator's drain plug. It could be anywhere along the bottom of the radiator, and will be either a screw plug, bolt plug or a petcock (simple drain valve). Be sure you have your used coolant receptacle in place under the drain before you open it up. Look at the bottom of the radiator facing the engine. I there is none then pull off the lower hose.
I have not personally used Liquid Fire Drain Opener to unclog a drain before.
No, Drano is a drain cleaner and should not be used to flush a radiator. It is not designed for automotive use and can cause damage to the radiator system. It's best to use a radiator flush solution specifically designed for automotive cooling systems.
i believe it is about 8 quarts to flush and fill the system. i believe it is about 8 quarts to flush and fill the system.
Using kerosene as an engine flush is not recommended. Kerosene can effectively clean deposits and sludge, but it may also damage engine seals, gaskets, and other components due to its harsh nature. Instead, it's better to use commercially available engine flush products specifically designed for this purpose, as they are formulated to clean without harming engine parts. Always consult your vehicle's manufacturer guidelines before performing any maintenance.
The drain plug for the antifreeze on a 2008 Dodge Avenger is located on the engine block, typically near the water pump. To access it, you may need to remove some components for easier visibility. Additionally, there may be a drain valve on the radiator itself, which can be used to drain the coolant. Always ensure the engine is cool before attempting to drain antifreeze.
Avoid putting solid matter down drains. Periodically (1-2 times a month), a drain cleaner should be used. About once a year, it's a good idea to flush the entire drain.
No, not in itself, unless you got water on some electrical parts. You do not flush the internal engine with water. BG Chemicals has the best flush I personally have used in my repair shop.
Where are the drain plugs for engine, transmission, etc and can the same oil be used for all three compartments
There are typically three levers in a city drain system: the flush lever, the control lever, and the drain lever. These levers are used to manage the flow of water and maintain the city's drainage system.
The device used to flush a toilet is called a flush handle or flush button.
The device used to flush a toilet is called a "flush handle" or a "flush lever."