Yes they can. The lens are clipped on and have a gasket between the lens and the reflector.
Turn signal lever assembly can be replaced without removing the steering wheel. See instructions at the attached link question about replacing the headlight switch on a 1999 Subaru Forester.
Headlight Bulb Replacement * Open the hood and locate the bulb assembly on the back of the headlight housing.On the right side headlight remove the two screws and the plastic shield for access to the bulb * Unplug the electrical connector and detach the retaining ring * Withdraw the bulb assembly from the headlight housing * Without touching the glass with your bare fingers insert the new bulb into the assembly Headlight Housing Replacement * Disconnect the negative battery cable * Remove the headlight bulb * Remove the radiator grille * Remove the parking light housing * Remove the retaining nuts and bolts detach the housing and withdraw it from the car
no
To replace the headlight on a 2009 Jeep Laredo, first, open the hood and locate the headlight assembly. Remove the screws or clips securing the assembly and gently pull it out. Disconnect the wiring harness from the back of the headlight bulb, then twist and remove the old bulb. Insert the new bulb without touching the glass, reconnect the wiring harness, and reassemble the headlight assembly.
Yes there is! You need to get a pair of pliers (called "snapring pliers")to remove the retainers (the little silver "do-dads" holding the headlight assembly in place... on the back of the grille opening panel). There's 2 of them on each assembly. You get those off and the headlight assembly practically FALLS out!!
To replace the headlight on a Toyota Solara, first, open the hood and locate the headlight assembly. Disconnect the electrical connector from the back of the headlight and remove the retaining clips or screws holding the assembly in place. Carefully pull out the old headlight bulb, insert the new bulb without touching the glass, and reattach the connector. Finally, secure the headlight assembly back in place and close the hood.
To replace the headlight on a 2007 Ford Explorer Sport Trac, start by opening the hood and locating the headlight assembly. Remove the plastic cover or bolts securing the assembly, then disconnect the wiring harness from the back of the headlight. Carefully twist and pull out the old bulb, and insert the new bulb without touching the glass. Reconnect the wiring harness, secure the headlight assembly back in place, and close the hood.
To change a headlight on a 2002 Cadillac Escalade, first, open the hood and locate the headlight assembly. Remove the plastic cover or the retaining screws to access the bulb. Disconnect the electrical connector from the old bulb, then twist and remove the bulb from the socket. Insert the new bulb without touching the glass, reconnect the electrical connector, and reassemble the headlight assembly.
Try replacing the washer seat.
To replace the headlight on a 1976 Mercedes 450SL, first, ensure the vehicle is turned off and the battery is disconnected for safety. Remove the headlight assembly by unscrewing the retaining rings or clips, then carefully pull out the old headlight bulb. Insert the new bulb without touching the glass, reattach the assembly, and secure it with the retaining rings or clips. Finally, reconnect the battery and test the new headlight to ensure it functions properly.
sort of you can remove the fuel pump assembly (its in-tank)the clean of the mesh screen best you can do
Headlight Bulb Replacement * Open the hood and locate the bulb assembly on the back of the headlight housing.On the right side headlight remove the two screws and the plastic shield for access to the bulb * Unplug the electrical connector and detach the retaining ring * Withdraw the bulb assembly from the headlight housing * Without touching the glass with your bare fingers insert the new bulb into the assembly Headlight Housing Replacement* Disconnect the negative battery cable * Remove the headlight bulb * Remove the radiator grille * Remove the parking light housing * Remove the retaining nuts and bolts detach the housing and withdraw it from the car