yes,so they can see where they will go at night.
It enabled people to work longer hours.
same way as this:How_do_you_change_the_fron_turn_signal_on_a_cadillac_srx
I think you better check your question - Thomas Edison invented the light bulb.
Take hold of the turn signal light bald connector, push in and turn. The light bulb connector will come out with the light bulb. Remove the light bulb the same way you remove the connector. Reverse the process to install the new light bulb.
a lighthouse with stripes around it so the light house knows which way to screw the bulb
You would need to remove the four screws on the front of the light remove the light from the back and change the bulb replace the light in the opposite way.
yes
peel off carpeting behind the tail light from the trunk. there should be bulb holders- pull out the holder that holds the busted bulb. you can do this by slightly turning it and pulling it out. change the bulb and replace the holder the same way you removed it.
you have to buy a new light they do not come with replacement if u get on eBay and buy a light u can replace it that way for cheap.
Before the light bulb was invented, people used lanterns, candles, and fire for light. Today, with all the technology going on, we use electricity to produce light such as for the light bulb. So the most commonly used way to make light is by electricity.
Thomas Edison is quoted as saying "I did not fail, I found 2000 ways how to not make a light bulb." He did finally succeed in finding the one way to make a light bulb.
When a light bulb burns out it no longer makes light. This is because there is no way to connect the flow of electricity.