0
Can the white plastic end pieces on a 2001 corsa gear linkage be replaced?
Kolbos
You may have to replace the linkage but the dealer should have one or the other. Probably not an after market piece.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you change the gear lever linkage mechanism on Corsa?
rip the car apart and get a macanic to do it
Why has my Gearstick gone sloppy on my Vauxhall corsa?
your corsa gearstick has gone sloppy because it needs a new gear linkage. its a common problem on corsa'a and the part is about £60 from the vauxhall dealer
Opel Corsa cut out while driving do not start?
Coil pack needs to be replaced
What is the reason for the water boiling on an opel corsa?
The head gasket has blown and needs to be replaced.
Vauxhall corsa 56 plate gear stick just loose and cannot get in gear?
Your gear linkage would have gone, the same happened to mine, If you look under the bonnet where the gears are connected, it's like a plastic foot-long connector. If you're not sure on how to fit it, take it to your garage & you can get them to do it :)
How do you replace clutch pedal plastic clip on vauxhall corsa?
You need to replace to whole Pedal
What is the easiest way to access the fuel tank in a vauxhall corsa?
THE REAR SEAT, ITS IN A BLACK PLASTIC BAG.
How much to change a head gasket on a 1.2 l corsa?
pieces of rubber seal found inside the thermostat housing on my corsa 1.2 sxi (04) plate, where did the rubber seal or gasket come from?
Why does your corsa utility 1.4 you jerk when driving?
Spark plugs need to be changed. had the same problem and it disappeared when I replaced the plugs.
When does the camchain on a vauhall corsa 1.2 16v get replaced?
it should last the life of the car unless its making a seriously loud noise
How many miles should a corsa club timing chain last?
Should last the life of the engine and be replaced when the engine is overhauled.
Gears difficult to change on 1997 corsa especially reverse?
The gear linkage on top of the gear box on this shape of Corsa suffers from wear very commonly. It seems that the ball & socket joints get water in them, causing the metal ball to rust, and then wear away the plastic socket. The mechanism has been re-designed with the aim of preventing water getting in the joints. There are two repair kits available from GM, a small kit for use when 1st and 2nd are hard to select, and a larger kit that is needed if reverse is hard/impossible to select.
