0
Can water drain from a frost free hydrant if it does not shut off completely?
Wiki User
∙ 11y ago
No. Water will continue running until hydrant is either repaired or replaced.
Wiki User
∙ 11y ago
Wiki User
∙ 10y agoA frost free faucet is designed to stop water lines in the faucet from freezing at below freezing temperatures. There is no water in the line, so it has now where to go.
Add your answer:
Earn +20 pts
What is the opposite of hydrant?
The opposite of hydrant (water-releasing structure) could be: -- drain (where water goes, i.e. back out) -- inlet (where water enters the system, as opposed to where it exits)
Can a heated hose be kept attached to a frost free hydrant or will this cause the hydrant to freeze by holding the water from draining back?
what do you mean by a "Heated Hose"??
When a yard hydrant partially open does water leak through the drain hole or is the water coming out the faucet the only water being used?
No, the plunger blocks the drain hole when the handle is lifted. See this link for more information. http://www.woodfordmfg.com/Woodford/Yard_Hydrant_Pages/how_fpyh_works.htm
Do you need to completely drain antifreeze when replacing water pump?
yes
What enerygy is behind a non flowing fire hydrant?
The energy behind a fire hydrant that is not flowing water is known as "static pressure". This is the water pressure that is normally available from the water main when the hydrant is closed.
What are the difference between hydrant and hydrant monitor?
hydrant is the sub part of fire water network from which water shall be discharged to on fire parts, and from where the hydrants gets water is the monitor, i.e from monitor water shall be distributed to hydrants.
Why dump water from a fire hydrant?
There is no reason to dump the water from a fire hydrant. The only reason a fire hydrant should ever be opened is if there is a fire or people are dieing from lack of water on a severly hot day.
Is fire hydrant water potable?
No
What is a device to draw water?
hydrant
How does a frost free hydrant work?
Frost-free yard hydrants are installed to provide water to various locations in the farmyard during all seasons of the year. They are manufactured and installed in such a way that they will operate throughout the winter without auxiliary heat.OperationA major component of a hydrant is a stop-and-drain valve. This valve is located below frost level, usually 2 to 3 m below the ground surface. The valve is operated by a lever or wheel that is connected to the valve by a control rod. When the valve is open, water flows from the supply line, through the valve, up the riser pipe and out through the head of the hydrant.When the valve is closed, the flow of water stops, and a drain hole in the valve opens. The water contained in the riser pipe flows out of this drain hole into a gravel bed, leaving the riser pipe empty and preventing ice formation.InstallationIt is important that the riser pipe drain quickly during cold weather to minimize the formation of ice inside the riser pipe. At least one cubic yard of clean, coarse gravel must be placed around the stop-and-drain valve of the hydrant. A container such as a heavy plastic bucket placed upside down around the valve will also aid the quick draining.Any adjustment of the hydrant should be done before backfilling. Proper adjustment of the hydrant will allow: * unrestricted flow when the valve is open * no seepage past the valve when it is closed * proper draining of the riser pipe when the valve is closed * no leakage through the drain hole when the valve is open A hydrant can be checked to see if it is draining by allowing the water to run, shutting off the hydrant and holding the palm of your hand over the end of the spout. If suction is felt, then the hydrant is draining.The water pipe supplying the hydrant should never be less than 1 inch (25 mm) inside diameter. Hydrants should be located where they will not be subject to damage by livestock or machinery.Hydrants should never be installed in or near wells or pump pits. Under the new water well regulations, it is illegal to locate a well inside a pit. Drainage from the hydrant can contaminate the well or flood a pump pit.For example, the end of a hose being used to fill a sprayer tank may become submerged in the chemical solution. If the hydrant it shut off and starts to drain, a siphoning action will be started, and the chemical from the sprayer tank will be siphoned into the drainage area. If the hydrant drains into the well casing or well pit, the result may be considerable contamination.An air gap must always be kept between a hose outlet and the highest possible water level in any tank. Anti-siphon or vacuum breaker valves are available for hydrants that will help prevent this very common type of accident.Using HydrantsIf a hydrant is to be used frequently during summer months, it may be advantageous to put a hose bib or globe valve on the outlet of the hydrant. The hydrant valve can then be left open over the summer, and the gravel bed will remain dry to allow better winter drainage.If a hydrant is used in winter, a large volume of water, 25 or 30 gallons (100 - 150 litres) should be drawn off occasionally. This action will melt the layers of ice that can build up in the riser pipe.Hydrants make excellent risers for automatic stock waterers (see Agri-facts 716 (C52) Automatic Livestock Waterers). They allow individual waterers to be shut off in winter or during prolonged winter power failures.Figure 1. Hydrant operationFrozen HydrantsA hydrant can freeze due to improper valve adjustment, a saturated drainage bed, a plugged drain hole or improper use, such as incomplete shut off or the constant withdrawal of only small amounts of water.Should a hydrant freeze, it should be thawed as soon as possible to avoid damage. Hydrants frozen above ground level can usually be thawed by heating with an electric heat tape, a torch or hot water. If the hydrant is frozen below ground level, the head will have to be removed and hot water poured down the inside of the riser pipe. This step is most easily accomplished by soldering a copper tube to a funnel and pouring the hot water through the funnel and tube to the point where the ice has formed. The tube is pushed down the riser pipe as the ice melts.For further information, contact Alberta Agriculture and Rural Development:Alberta Ag-Info Centre toll-free at 310-FARM (3276)orAgricultural Water Specialists at the following locations:Lethbridge (403) 381-5846Red Deer (403) 340-5324Edmonton (780) 427-2963Prepared byKen Williamson - Agricultural Water SpecialistAlberta Agriculture and Rural DevelopmentSource: Agdex 716 (C51). Revised March 2008.
What is a street water outlet called?
hydrant:)
Why is the common name hydrant called firehydrant?
A hydrant is any discharge pipe with a valve and spout at which water may be drawn from a water main. Obviously we nearly always see these in conjunction with supplying water to fight fires, but calling it a fire hydrant makes that specific. It also probably gets tacked on to emphasize the purpose of the hydrant.
