answersLogoWhite

0

If you know what you're doing, you can probably accomplish that in a 1A circuit.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Can I safely install a 20A outlet on a 15A circuit?

No, it is not safe to install a 20A outlet on a 15A circuit. The outlet should match the circuit's amperage to prevent overloading and potential fire hazards.


Is it safe to install a 15A outlet on a 20A circuit?

No, it is not safe to install a 15A outlet on a 20A circuit. The outlet should match the circuit's amperage to prevent overheating and potential fire hazards.


Does the NEC code allow multiple 20A receptacles on a 20A circuit Put another way does a 20A receptacle with T shaped neutral slots imply that no other outlets are that circuit?

The National Electrical Code (US) allows up to thirteen 20 amp receptacles on a 20 amp circuit. 120V x 20A = 2400 VA each duplex receptacle is calculated at 180 VA 2400 / 180 = 13.3333 receptacles, since you can't put a third of a receptacle in, you have to round down to 13.


Do you have a 15 0r 20 amp circuit?

Go to your distribution panel and shut off the breaker that you think is the circuit in question. If the circuit becomes de-energized then the breaker you just turned off feeds that circuit. Look on the handle of the breaker and the number you see is the amperage of that circuit. <<>> Determination of a 15 or 20 Ampere circuit is normally indicated by a combination of a 20A breaker and a 20A dedicated outlet. A 15A circuit normally has multiple outlets; not typical in a 20A circuit.


How many outlets can be wired to a 20A circuit?

No more than 13.


Can you run 2 small refrigerators on the same circuit as a dishwasher?

It will depend on how big the circuit is if its a 20a no if its 40a yes!


What does 20A CB stand for in a car fuse?

20 amp circuit breaker


Can you run a 110v 20a circuit off one leg of a ge thqp 220v 20a breaker?

No, you cannot run a 110V 20A circuit off one leg of a GE THQP 220V 20A breaker. A 220V breaker is designed to provide two hot legs, each supplying 110V, but when using only one leg, it does not provide the proper grounding or neutral configuration needed for a standard 110V circuit. Additionally, this could lead to potential safety hazards and code violations. Always consult a qualified electrician for proper circuit configurations.


What is the right circuit break to be used for lighting circuits?

Usually 15A or 20A, but it depends on the wire used.


Can you use a 220V 20A fuse to replace a 125V 20A?

No, it is not safe to replace a 125V 20A fuse with a 220V 20A fuse. Fuses are designed to protect electrical circuits from overloading, and using a higher voltage fuse could lead to damage or fire hazards in the circuit. Always replace a fuse with the same voltage and amperage rating as the original.


What minimum number of 150 W light bulbs must be connected in parallel to a single 240 V household circuit to trip a 20.0 A circuit breaker?

150W = 240 volts * .625Amps. Assuming the 20A breaker trips at exactly 20A, 20/.625 = 32 lights.


How do you upgrade from 120V 15A to 120V 20A or from 240V 20A to 240V 30A?

You have to replace the wire (as you are increasing the current capacity), the outlet, and the breaker. Essentially you have to remove the old circuit and put in a new one. You can't reuse parts of the old circuit as you are increasing the current capacity and they would be underrated.