you could but the pipe might fill with rain water during a storm, but as long as it doesn't have any opening/cuts in the wire insulation it should be fine.
Paper insulated wire is coated with DuPont's NOMEX Paper wrap which can withstand temperature over 200 degrees centigrate. Enamel insulation usually is coated over aluminum wire and shipped from 3rd world countries to put in our houses because housing contractors don't care if your house burns down. bottom line is money, enamel is cheaper.
If the solenoid wire is not insulated the number of turns will be reduced by the uninsulated wires touching and shorting out the turns.
A connection from a power source, through a load and a return back to the power source. <><><> An example: electricity is supplied to the light switch on the wall through an insulated copper wire, even though the switch is in the off position electricity is present. There is another insulated copper wire going to the light bulb. When you flip the switch the circuit is completed and the light bulb comes on.
If you don't have insulation on the wire, then the loops in the coil will touch each other and short to each other. Instead of have x number of turns on the coil, you would basically have a solid conductor if the wire was not insulated.
An electrical appliance which is double insulated does not have an earth wire fitted. The appliance is designed in such a way that the electrical parts can never come into contact with the outer casing of the device. Common double insulated appliances are hair dryers, radios and cassette players.
No. Extension cords, whether they're of the indoor or outdoor variety, are just pieces of insulated wire and offer zero surge protection.
An insulated wire called a lead is inserted into an incision above the collarbone and guided through a large vein into the chambers of the heart.
Yes, if it is not an insulated wire. If it is bare copper it is always ground. But the hot and neutral wire are also copper, they are just insulated.
Phillips Insulated Wire Company Complex was created in 1898.
magitising
a hose
An insulated wire is made of a conductor surrounded by an insulating 'jacket'.
Except for the ground wire they must be insulated.
It just means that the bare wire is insulated by a non-conducting coating. In home wiring the typical circuit has a black wire (Hot), a white wire (Neutral) and a bare wire which is ground.
A magnet consisting essentially of a coil of insulated wire wrapped around a soft iron core that is magnetized only when current flows through the wire.
So the wire doesn't short itself out. The electricity needs to go through all the windings individually.
So the wire doesn't short itself out. The electricity needs to go through all the windings individually.