0
Can you butt joint composite deck boards or is it necessary to leave a gap?
Wiki User
∙ 14y ago
You should follow the MFG for gaping guidelines as your first rule. You can go to
the website of the MFG and usually get the installation instructions.
If you don't like the gap, you can go with vinyl, most inter connect and are not gaped and aslo have a water channel. But its a lot more money for this. On the other hand,they take more abuse, don't fade, and last longer.
They should all have the same gap, 1/4, or 1/8, same all gap between parallel boards.
This gives the even appearance, if not, the boards that are butted stand out.
When doing designs, 45deg can meet. This is just how I have done all my compost decks.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Which glue holds two borads together the best?
TiteBond ll will hold two boards together best. Clamp your joint and leave clamp on for 6 hours.
How many 2 by 4 by 20 boards would you need to frame a 20 by 20 floor?
Assuming you are laying the boards flat, you will need 137 boards if you leave no gaps between them.
Is it necessary to leave the Number Lock Key On all the time?
Is it necessary to leave the Number Lock key On all the time
What did the incas leave behind?
they left there skateboards and surf boards because the surf was not narly
Why is it necessary to have different sets of measurements for the leave width and length?
Not only is it necessary, it is not advised.
Why doesnt a ghost from an ouija board leave you alone?
Ouija boards get the player in contact with evil spirits. That is why.
Should the last joint tenant survivor will his share of his estate to anyone he chooses?
Yes. Generally, in a joint tenancy with the right of survivorship, the surviving joint tenant owns the property and can leave it to her heir(s) by her will.
Give Those Deck Boards a Little Space?
To achieve a faultless finish on your new deck, be sure to stagger the joints when you install the deck boards. When nailing the deck boards on to the frame, be sure to leave even spacing between the boards. Most experts recommend 1/8 inch between two inch boards. To avoid measuring over and over, simply place a 16d nail between the boards to keep them in place and insure you have the right measurement.
Do you need to place the gear at N when stopping at traffic lights or to leave it on D?
No this is not necessary. Leave it in Drive.
I am a joint tenant will I be covered if they leave a window open and I get burgled?
Depends on if you have renter's insurance or not.
When you travel do you have to put your skateboard in the bag or can you Carrie it on your hand?
leave it in your hand, if your bag is made to strap boards on the outside, strap it in!
When are the SAT tests?
You can find out on College Boards website, I'll leave a link below for the most current test dates.
