Yes you can. I'd check the valve guides for wear while you're at it though. If the valve guides are bad a new seal isn't going to be a long term fix.
The o ring style seal goes on the lower groove, the valve keeper goes in the top groove.
Do a valve job. This is more complicated than it sounds, you might be better off sending the head to your local machine shop for the valve job.
Replace the valve seal and check the valve guide for wear.
valve cover gaskets, front main seal, rear main seal, timing chain cover gasket, could be any of these. ... How would i change a valve cover gasket on a 96 camaro rs. Their is a steel plate in the way on the left side.
It is a seal that prevents engine oil from entering the valve guide causing oil loss and oil burning.
You put your dick on the valve cover and rub mayonnaise on your dick and smear it everywhere to provide a leak-proof seal and that will enable the valve cover to become horny and start kissing your dick goodnight. Thanks and ChaCha!
In a two-stroke reed valve engine the reed valve is used to seal the fuel air mixture in the crankcase.
Leaky gaskets(oil pan, valve covers, rear main seal, etc), or worn valve guides or bad piston rings. My 89 Chevy 1500 4.3l v6 has 203,000 miles and uses virtually zero oil.
how do i doa Valve adjustments for a Chevy 350 5.7l?
where is the PCV valve located on a 2004 chevy tahoe
"Where is the heater controll valve on a 2001 Chevy S-10 controll Valve? "
where is the canister purge valve located on a 03 chevy venture