No, you will need to fix the failure.
I believe it's called "Limp Mode", not "Safe Mode". The Car doesn't want to shift, so it's like in 2nd gear all the time. That's "Limp Mode" or Limp Home Mode. -- It cost me 3,000.00 to find out the 50.00 processor was bad.
You have to repair the cause of the code that put it in limp mode.
The transmission computer default to limp mode when it detects a malfunction. It will also set a trouble code. You need to have the code read with a scan tool to know possible causes.
You have to fix the problem that caused the trouble codes that put it in limp mode.
thats called "limp home mode" and its a very obvious sign you have something wrong with your tranny. you probably need a new one or to get the old one rebuilt
fix the problom that put it in limp home mode then reset the computer
the
the trans is in what is called "limp in" the trans controller auto locks it in 2nd gear when it sees a fault. they are many different conditions that can cause this to happen.it could be something as a speed sensor or something insideof the trans like burnt clutches.i would have it checked ata dealership.like i said ,it could be a 50.00 fix or it could run into the thousands.believe me ,i am a Chrysler cetified ASE mastertech,with over 20 years with them and i have rebiult hundredes of them.
The computer won't release it from limp in mode until the underlying problem is fixed and the trouble code cleared.
The transmission computer has detected a malfunction and set a code.
$200-$2500
yes it can my 91 rodeo 3.1 v6 has that problem as we speak,tranny light flashing and in limp mode