In the UK builders' hand-tools for use on outdoor sites run on 110 v and you can get a portable 3 kVA transformer to convert 240 to 110 for about £30 if you look around.
The 110 v secondary has a centre-tapped earth so that both lives wires are 55 v to earth.
Some electrical motors are dual voltage rated. You will see this on the nameplate of the motor. Usually 120/240 under the voltage supply and under the full load amps (FLA) the two currents represented like 10/5 amps. Plug in power tools don't usually have this feature as the most common household plug in voltage is 120 volts.
No, it won't get enough power and won't work.
No, the appliance is wired for a heavier circuit (240v). You wouldn't even be able to plug it in because the 240 plug and the 110 receptacle don't match. They're designed that way so they're fool proof.
If your trying to plug in a 110 Volt lamp into 240 volt outlet the answer is simple. You must buy a step down transformer, or your lamp will burn out.
First, someone would have changed the plug before that would be possible. 240 Volt receptacles do not accept 120 Volt plugs. Second, IF someone changed the plug on the compressor, then plugged it in using both legs of the 240 Volt circuit, the compressor motor would self destruct instantly; internal wiring would burn and you would smell the burning insulation.
It is not just the outlet, but the wiring and breakers that need to be compatible with your 240 Volt appliance. Get an electrician to look at your requirement.
no
No, it won't get enough power and won't work.
The pin configuration of the 240 volt receptacle is different from a 120 volt pin configuration. This is a safety factor to prevent the wrong voltage being applied to the wrong devices.
The pin configuration of the 240 volt receptacle is different from a 120 volt pin configuration. This is a safety factor to prevent the wrong voltage being applied to the wrong devices.
Yes
Not unless you have a 110 volt supply to plug it in to. The standard General Power Outlet in Australia is 240 volts AC at 50 Hertz.
No, the appliance is wired for a heavier circuit (240v). You wouldn't even be able to plug it in because the 240 plug and the 110 receptacle don't match. They're designed that way so they're fool proof.
If your trying to plug in a 110 Volt lamp into 240 volt outlet the answer is simple. You must buy a step down transformer, or your lamp will burn out.
Not unless you have a 110 volt supply to plug it in to. The standard General Power Outlet in Australia is 240 volts AC at 50 Hertz.
It won't run.
You need a step-up transformer, to go from 110 to 220-240 volts. Then a 110 volt supply can operate 240 volt equipment.
First, someone would have changed the plug before that would be possible. 240 Volt receptacles do not accept 120 Volt plugs. Second, IF someone changed the plug on the compressor, then plugged it in using both legs of the 240 Volt circuit, the compressor motor would self destruct instantly; internal wiring would burn and you would smell the burning insulation.