Yes... is the short answer. The toilet has a trap in itself. You would have to be able to break out the floor and put a P trap in the existing line
That would make for an awfully low toilet.
Maximum distance of the toilet to the drain is 6 metres (20 feet). The angle of drop is set by the branch at 112 1/2o, which equates to about 1/4" of drop per foot.
If you just plan on putting the toilet on top of the floor drain the answer is no. The floor drain if it leads to a septic system or city sewer would have a trap in the line which will not work with a toilet. Depending on the size of the pipe 3" minimum you could cut the floor and tie a toilet into the line. It would also have to be properly vented. I would consult a plumber on the job. Its also possible that the floor drain just goes to a dry well which could not be used. Even if it could not be used there are other ways to install a toilet below the septic or sewer line.
This could be an old floor drain. Check to see if you have another floor drain in a different part of the basement. ...It's not a drain. That is a rough-in or prepared area to install a bathtub or shower. It is normanlly a squared off hole near some other PVC pipe stubs sticking up for toilet and sink connections.
If the toilet and shower are in an upper floor then there is a PVC drain for both that will drain to either the sewer or septic. If there is a vertical piece to this, as there is in my basement, then you actually get some dribbling and running sounds from the water 'falling' down that vertical PVC. I get this same noise from the washing machine on the main floor draining down to the basement.
Probably not. There is no vent for that drain, it did not need one for a floor drain. A toilet is trying to push against the air pressure in the drain.Normally a decent plumber will install a floor drain with in 15 feet of a vented line or will vent the FD in case irt exceeds the 15 ft ruleA Floor drain can be as small as 2" diameter and thus it is undersized for a toilet and a floor drain alread has a trap and a toilet would thus be drouble trapped
The toilet flange is usually above the floor level. You would have to cut it off the drain pipe and cap it. How you do this depends on what type of pipe the drain is made of. Even if the drain should be below the floor level, you have to seal the drain or sewer gas will come up from the drain.
A basement standpipe is an open-ended and watertight pipe inserted in a floor drain to prevent a flooded basement.
You have a grinder pump that boosts the sewage up to the main floor to enter the drain system. The float in this pump system is not working correctly and the standing water level in the tank is too high. Adjust the float, it will cure your issue.
your kitchen drain and floor drain are on same line, and needs to be snaked
The wax ring which seals the toilet to the drain is leaking. turn off water, drain tank by flushing. Disconnect water line. remove tank, unbolt toilet from floor. Remove any old wax from toilet and drain. Replace with new wax ring. Reset toilet and press firmly into place.
If you have a basement floor drain, chances are that you have a clog downstream somewhere, and it's backing up into your basement.