0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How is a microcontroller programmed?
That depends on the specific microcontroller.
What is mean by pic in microcontroller?
The PIC is a specific architecture of microcontroller.
Can you connect a 24v dc motor to household current?
You need a DC power supply in order to connect a 24v DC motor to household power.
Why using pullup-resistors in 8051 microcontroller?
to determine the state condition of microcontroller's input when microcontroller is reading the input port
What is the difference between AVR microcontroller and pic microcontroller?
The difference is base on the requirement of their0 application.
Why you using micro controller NoT micro processor?
Microcontroller have inbuilt memory, interrupts, etc. Which you will need to connect externally in microprocessor. Thus, Microcontroller is better than microprocessors
What is the Different Between Microprocessor and Microcontroller?
The basic difference between the microprocessor and microcontroller is that we can interface a microcontroller directly means "for example we can directly connect a keyboard to microcontroller to any of its ports"....where as for microprocessor we can't interface directly...we require a circuit board since it requires ram,ic's.....etc.,! beyrojac mahinay
6 wire unipolar stepper motor pin connection?
tel me the connections of 6wire stepper motor with 8051 microcontroller
How speed control of single phase induction motor by 8051 microcontroller?
A feedback control system can be made involving microcontroller 8051, inverter(gating circuit), power processing unit, induction motor whose speed is measured via digital tachometer. The microcontroller will act as a Frequency Counter, Comparator and PID Controller. The output from tachometer(digital) will be given to microcontroller which will compare this to the reference signal and then pass the control signal to gating circuit.The power unit's output will be given to motor.
Can you operate dc motor using computer via microcontroller?
Yes. You probably don't want to do so directly unless it's a really small motor. An H-bridge, or similar circuit is probably easiest to use. The microcrontroller would interface with the computer, likely through a serial link. The microcontroller would then control the H bridge through several outputs. Depending on the microcontroller, H-bridge design, and motor to be controlled, the microcontroller might not be able to drive the H-bridge and an intermediate driver chip may be needed.
How to connect a mechanical load to a motor?
To connect mechanical load to a motor, you couple it to the shaft of the motor.
How do you burn the software on a 8051 microcontroller?
You will need a 8051 device programmer that connect to a PC with software to drive the programmer
How do you install a 95 contour sunroof motor?
Connect the sunroof motor with the sunroof motor retaining bolts. Connect the sunroof linkage. Connect the wiring harness to the back of the sunroof motor.
How is a microcontroller programmed?
That depends on the specific microcontroller.
Difference between Z86E04 microcontroller from PIC microcontroller?
x
What is mean by pic in microcontroller?
The PIC is a specific architecture of microcontroller.
What is the voltage of 8031 microcontroller?
The voltage of the 8031 microcontroller is 2.7V to 5.5V.
