answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-09-12 14:38:16

I have a 1995 Nissan pathfinder and the alarm computer was under the driver seat. I just took out the seat and unplugged the alarm computer. Not sure if it's the same on a 1994 Nissan pathfinder.

012
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


The easiest way to disconnect the 1994 Nissan Pathfinder car alarm is to remove the fuse. The location of the car alarm fuse is listed on the inside cover of the fuse box.


You can not disconnect the factory alarm, it is built into the computers.


How car i disconnect the alarm system of Nissan quest 2005. Disturbing the neighbours



The factory alarm can not be unhooked or disabled.The factory alarm can not be unhooked or disabled.



For instructions on how to disable a factory alarm, check out the related link below.


I belive its in a box under the driver seat.


trying to change steering column in 96 explorer and alarm went off how do i disconnect the alarm


The factory alarm is built into the Body Computer. It is not possible to unhook it.


The factory alarm is part of the engine and body computers, it can not be disconnected.


The factory alarm is built into the body and engine computers and can not be removed.


The factory alarm is part of the body computer programming and can not be removed.


The factory alarm is an integral part of the engine and body computers. It can not be disconnected.


Trace down the alarm box and cut the wires off. The alarm is not a factory option.


how to disconnect the factory alarm system on a 96 ford explorer


The factory alarm is part of the body computer programming and can not be removed.



under dash 4x4 gold box left side steering wheel.... hard to get out but you can unplug it


Under the front passenger seat, there is an electrical harness. Simply unplug the connection. This should disable the alarm.


The factory alarm does not have individual fuses. The engine and body computers both control portions of the alarm.


You can use your key in the door to unlock the car which usually disables the alarm. If you want to disconnect the factory arm, you would have to access the drivers kick panel and located the dk.green/black wire and disconnect it.


I am researching this myself due to a faulty alarm that keeps me from starting my own car. As soon as I get the answer I'll pass it along.


To disable the factory alarm system on a Ford Ranger, you would have to disconnect the remote entry module (REM). However, if you do that, the keyless remote and driver's door keypad will no longer work.


If it is a factory alarm, then this information can be found in your owner's manual. Don't have one, get one. Dealer or salvage yard is a source. If it is aftermarket and you don't have the manual, contact the manufacture of the system. the factory 'security system' can be disabled by closing the door, and locking and unlocking it with the key.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.