Want this question answered?
I don't know if it is the same but the EGR valve on my 1977 Ford 302 was underneath the carburetor at the back of a spacer
point gap 1978m ford
Here is the installation instructions for the Edelbrock Performer aluminum intake manifold for a Ford 351M/400...hope it helps out. http://www.edelbrock.com/automotive_new/misc/tech_center/install/2000/2171.pdf
not very much
It has 325hp and 375ft. torque
For a 351m engine the oil sending unit is located on the top of the engine between the carburetor and the firewall.
= Ford Throttle Body Spacer Description = In order for the engine of a Ford to run well, it needs a high volume of dense air coming into the combustion chamber at all times. Increasing the amount of air coming in to the engine will give the engine a power boost, and the Ford throttle body spacer is just the part to do the job. When installed, it will sit between the throttle body and the cold air intake. As the air comes into the Ford throttle body spacer, it is accelerated by a set of ridges that induces a vortex pattern into the flow. This allows the cold sir intake to move air in quicker. The Ford throttle body spacer also compresses the air, so that a larger amount will fit into the combustion chamber. The engine's computer will then increase the amount of fuel injected into the mixture, and when the combination is ignited, the resulting explosion will push the pistons down with more force. With the Ford throttle body spacer installed, the vehicle will gain several horsepower, and it will also see an increase in gas mileage. Because the hardware and gaskets that are required to install the Ford throttle body spacer are included in the kit, all that will be needed is a few simple tools. After the cold air intake is disconnected from the throttle body, and the gasket removed, the Ford throttle body spacer and gaskets can be installed. We carry the Ford throttle body spacer for many models in our online catalog, and with an easy, toll-free phone call or through our secure web site, the unit can be easily ordered. http://www.car-stuff.com/fordthrottlebodyspacer.htm
On my 1977 Ford 302 engine it was mounted on the back of a spacer between the carburetor and the intake manifold - underneath the air filter - I don't know if yours is the same
.044 inch
yes,it will also fit a 351m and 429
http://boxwrench.net/specs/ford_351C.htm
Engine oil capacity, 5 qts with filter change.