not for very long without overheating. Replace as soon as possible
No
which freeze plug you want there are several. along both sides of block,at rear of block behind flywheel and also in both heads
Freeze plugs are located on the side of the block below the exhaust headers, and at the end of each cylinder head.
No ( not unless you want to wreck the engine ) If the freeze plug is " blown " than the engine coolant will just pour out
The engine will leak out coolant/antifreeze from the freeze plug area. Freeze plugs can be replaced, it may take a lot of work to replace one but they are made to be replaceable. It is not advisable to drive any vehicle with a blown freeze plug.
All you need is a socket that will fit inside of the freeze plug and a hammer to drive it back in the block. You don't need a special tool.
There is not a block heater on this car. My 1991 Ford Mustang 5.0 LX had a block heater but I can't remember where it was installed on the engine , I believe on the passenger side of the engine block in a freeze plug ( expansion plug ) hole
no such thing,freeze in plug
The steel freeze plug is better than a brass freeze plug. This is because the steel freeze plug can withstand high temperature from the engine block. Moreover, the steel freeze plugs usually fit very well.
On my ( 1991 ) Ford Mustang 5.0 liter the spark plug gap was ( .054 inch ) What year of Ford Mustang ?
drill a hole in it install a screw and pry it out then drive in a new one
Steel or brass freeze plugs are the best ones,rubber freeze plugs are just for temporary