0
a bad head gasket will result with compression and oil/coolant mixxing in the blocka badupper or lower intake gasket will result with coolant in crankcase or exaust manifold which causes white smoke comming out of the tail pipe...if your gonna change the upper or lower intake gaskets change them both at the same time... it saves you money in the long run
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the upper manifold gasket located on a 2000 Chevy s10?
Assuming this is a 4.3L engine, the upper intake manifold gasket would be between the upper intake manifold and the lower intake manifold.
Where is the upper intake gasket on a 2001 Chevy blazer?
It is between the upper and lower intake manifold. The gasket is an o-ring type.
How to change the front intake manifold gasket on a 1999 Chevy Venture?
there is no upper intake gasket, only a front and rear
What would leak from the upper right side of a 2002 Malibu engine?
if its a 3.1, the possibility is the intake manifold gasket!!
How do you replace a manifold gasket in a 95 Ford Windstar?
"Manifold gasket" ? whick one? Upper intake MG,Lower intake MG or exhaust MG? I thinks you mean intake MG. The Upper intake MG is easy on. Just undo the bolt and clear the gasket materal, then replace new upper intake MG. The lower intake MG is a little bit hard. Carefully clear the old gasket material on the manifold and head, clear the bolt nad bolt hole in the head, then carfully install the lower intake MGand double check the coolant passage in ordeer to void the coolant leading. The last step is to torque corectly the bolt. good luck.
Is there any risk to having a novice remove an upper intake manifold on a 1998 Ford Windstar to get to the fuel injectors Is there a gasket or something that I might ruin?
It should be fine, this is a very simple operation. No worries. Be sure to review the "Related Questions" below for extensive information about the Windstar intake manifold -including links to plenty of instructions on removing the upper intake manifold.
What is a plenum Chrysler 3.5?
It is another name for the upper part of the intake manifold.It is another name for the upper part of the intake manifold.
Removal of three sparks located behind the upper intake manifold on a 1995 Chrysler cirrus?
you must remove upper intake manifold to access these plugs
Where is a 2000 blazer coolant leak if coolant blows on left front tire?
check the upper intake manifold gasket you will need to remove the ac compressor to check this
Intake manifold gasket 93 ford ranger 4.0 5 speed leaking at the head is this a gasket or worse?
Should just be the gasket but check the upper side of the cylinder head while you have it apart to see if it has problems. Intake gasket leaks will present vacuum problems, if pressure is pushing air out of the affected area then it may be the head.
Where is upper manifold on 2001 s10?
Assuming this is a 4.3L V6, the upper intake manifold is directly under the throttle body.
How do you replace the intake gasket on a 1992 Chevy Lumina Z34?
I'll assume Lower Intake Gasket, since they tend to cause vacuum leaks. Get a manual from Autozone and expect about 4 hrs labor, you need to take off the upper intake manifold just to replace the Lower Intake Gasket. Probably should change/clean the PCV valve while ur in there. Good luck, man.
