0
Can you drive with one intake manifold runner stuck open on a 1997 Ford Windstar.?
Wiki User
∙ 15y ago
yes you can
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Can you drive a ford windstar with a faulty intake manifold?
Depends on how faulty it is... and in what way. There is a common problem with the 2nd generation of Windstars, 1999-2003, intake manifold bolts that causes a leak. See "Related Questions" below for more
Can you drive your car if it needs a new intake manifold gasket?
Yes you can drive it but it will run lean and get poor mileage with poor performance.
On a 1993 Pontiac Grand Prix 31 v6 is the intake manifold on the front and exhaust on the rear?
On the front and rear of what?? The Air Intake Manifold is on the TOP of the engine. the Exhaust Manifold are on the sides of an engine. On a front wheel drive vehicle, the engine is turned 90 degrees, so the exhaust manifold appears to be on the front and back of the engine, below the valve covers.
Where is the knock sensor located on a 2002 chvy 5.3 liter engine in a silverado 2 wheel drive?
Its under the intake manifold.
Why does your 1987 Bronco 2 jump and then die when you put it in drive or reverse?
I would check the idle air solenoid on the intake manifold
How do you fix intake manifold runner stack open in one e250 ford 1997?
Eventually you will have to replace it. They cost around $150.00 for the part. But, you can drive the truck for a long time without any real problem developing. A friend of mine has been driving his for almost two years that way.
Is Ford windstar 1995 front wheel drive?
Windstar mini-vans are front wheel drive.
Is the exhaust manifold the same for a left and right hand drive Jeep Wrangler Sport TJ 4.0L 1998?
It should be the same.. the standard jeep(left hand drive) the intake and exhaust are on the left side of the engine as well, so there is no need for a different manifold. so 99 % sure its the same manifold
Is the 1999 Ford Windstar Front wheel drive?
YES , the Ford Windstar is a front wheel drive vehicle
Where is the knock sensor located on a 2004 Chevy 5.3 liter 1500 4 wheel drive?
That year and engine size has 2 of them and there both underneith the INTAKE MANIFOLD. You can not see are get to them until you remove the intake.
Where is the coling temperature sensor at on a 1994 Bonneville?
The cooling temperature sensor is located on the drive belt end on the intake manifold on 3.0 and 3.8 liter motors. On 3800 motors it is located on the opposite end of the intake.
What does an automotive Map Sensors do?
A MAP sensor is an anacronym for "Manifold Absolute Pressure" sensor. The sensor has a vacuum line going to it from an intake manifold vacuum port. It senses the amount of intake manifold vacuum or pressure depending on how far open the throttle (your foot) is when you drive. Wide open throttle-foot to the floor, dictates low vacuum in the intake manifold. This device is all part of your engine electronic control devices/sensors used to make your engine run at peak efficiency and perform its best.
