Im currently trying to repair mine. Apparently a thyristor is the problem. I have a wall-o-brokenCircuitBoards and am trying to use thyristors from an lcd power supply but they seem to be dead, or the heat from the soldering gun is killing them before they even get a chance. I hope you fix yours. Heck, I hope I fix mine.
Because it is a type of lamp.
You can convert a clamp on desk lamp to a lamp with a regular base by purchasing a tabletop bracket for the lamp. This bracket can act as a base for the lamp.
a pole with a lamp on it.....
its a good lamp
The projection lamp, from the sound of things.
For the most part, desk lamps are not too complicated to fix. One will be better off buying the broken parts and replacing them rather than try to fix the broken parts because the parts for a desk lamp are usually inexpensive.
no you just replace them
Your on a ball (the earth), rotating in front of a lamp ( the sun)
Take it apart and repack with lamp wick
I did tell you to fix that lamp so go do it now!
You don't fix it, you replace it. Sometime buying a whole new lamp is about the same as buying just the ballast.Also you have to get the right one and then follow the colors on the wires to swap it out.Their are electronic ballasts and the older ones that hum.
how do you fix the lights on a camrey that are foggy
You butter the inside of the trunk lid and put 3 tsp. of jelly on the hood. Then say Abra-cadabra and stick some glue on your shoe and press on the gas. Ta-Da! That's how you fix it.
ball joint costs about £8.00
How do you fix a broken ball pump needle
Make sure the lightbulb is good. Get a new lamp shade if needed, and make sure the stand is good. If it is broke, either weld it or glue it and hold it with a clap for a day.