You can fix the shake weight by popping the silver end cap on the limp side, and simply align the hole to put the screw back in and tighten it.
Die or flat point
if the strip will flat we can measure its thickness easily but if it is not flat i.e. its surface is irregular then it will thick only from some points and its other area will be thin and we cannot measure its thickness easily.same is the reason for wire.
what is a screw
Just exactly the same way you screw into wood.
Yes, remove the nail. Fix-a-flat may work for a temporary fix but get a proper plug patch installed at your earliest opportunity. Take a crayon and draw an arrow on the sidewall showing where the nail was and you will be able to tell the guy at the tire repair where to look. The fix-a-flat also works better if the hole is on the bottom when you squirt it in.
No, you can fix it with a flat head screw driver and vise grips.
Put an inner tube in the tire.
flat screw drivers,insulated screw drivers,stubby screw drivers,torx screw drivers,striking screw drivers,pokers screw drivers.
flat screw drivers,insulated screw drivers,stubby screw drivers,torx screw drivers,striking screw drivers,pokers screw drivers.
it can fix wood, doors and all other bits of wood
Helicoils.
Fix a flat, you can get it at any dollar general store or Wal-mart.
Buy yourself graphine grease and apply or you can use a flat screw driver to tap it or pry it out. You can also use your ignition key if a screw driver is not available. Toyota has a new part to fix this problem. just order a replacement. it is covered under 3year 36,000 mile warranty if you fit the bill.
Screw fix
Flat. Should be flush with the side of the hammer.
Phillips head (the star lookin one) and Flat head (the flat one) :)