104VAC is the highest voltage less than 115VAC minus 10%, which is 104.5VAC. 127VAC is the lowest voltage greater than 115VAC plus 10%, which is 126.5VAC. Plus or minus 10% is considered to be the design basis range of standard 115VAC equipment, in order to maintain correct operation.
Any where from 110 volts to 130 volts alternating current is available from a 110 VAC outlet.
The formula you are looking for is W = A x V.
White is the neutral wire. Black is hot, green is ground.
In a parallel circuit the voltage is the same throughout and current flow is the total that each device (or load) draws. This is so everthing can be designed to run on one fixed voltage such as 115VAC for most small appliances and electronics. The voltage comes in to your house as 230 VAC between two wires (plus an earth ground) for dryers, ovens and other large energy hogs. 115 VAC is then available from either of these two hot wires relative to earth ground. If series circuits were used the voltage would vary from 115VAC available for a single load to something less as each extra load is added so in effect nothing would then work if they orinally were designed for 115VAC.
104VAC is the highest voltage less than 115VAC minus 10%, which is 104.5VAC. 127VAC is the lowest voltage greater than 115VAC plus 10%, which is 126.5VAC. Plus or minus 10% is considered to be the design basis range of standard 115VAC equipment, in order to maintain correct operation.
Any where from 110 volts to 130 volts alternating current is available from a 110 VAC outlet.
It will burn due excess current .
They are in tandem because they power a 220 VAC circuit, rather then a 110 VAC circuit.
24 VDC or may be 110 VAC
The formula you are looking for is W = A x V.
In the United States, 110-120/240 VAC is the standard.
White is the neutral wire. Black is hot, green is ground.
A duplex outlet is 115vac.
In a parallel circuit the voltage is the same throughout and current flow is the total that each device (or load) draws. This is so everthing can be designed to run on one fixed voltage such as 115VAC for most small appliances and electronics. The voltage comes in to your house as 230 VAC between two wires (plus an earth ground) for dryers, ovens and other large energy hogs. 115 VAC is then available from either of these two hot wires relative to earth ground. If series circuits were used the voltage would vary from 115VAC available for a single load to something less as each extra load is added so in effect nothing would then work if they orinally were designed for 115VAC.
Dubai uses 220 VAC at 50 Hz (in the USA, we use 120 VAC at 60 Hz). They also use the G type plug.
Most of the breakers in a panel will be 120 VAC. Double height breakers are 240 VAC. A triple height breaker probably indicates you have 3-phase power in the panel.