we used to drill a hole in top of all joint on top a a arm and insert self tapping grease (zirc )fitting some of them have a screw already all you have to do is insert grease fitting the answer is yes
the ball joints are not serviceable.
They are on the tie rods, ball joints, and the trac bar.
Factory ball joints do not have a grease fitting. If yours have been replaced, it is then possible it will have a fitting.
How do you replace your front ball joints on a Lincoln
Sealed ball joints are not designed to have grease added. They have been permanently sealed, and can only be replaced when there is a problem.
all the ball joints are self lubricated, meaning no grease fittings, you cannot grease them or the steering joints, you can grease the front and back u joints on the drive shafts,but that is all.
Lower ball joints. Grease nipple is accessible from the front
that vehicle has a total of 11 grease fittings. two upper ball joints two lower ball joints, two outer and two inner ball joints, two on the idler arm and one on the pitman arm.
EP2 grease is a type of non-corrosive lithium grease. Its main usage is in cars, more specifically for car parts like ball joints, U-joints, CV joints, etc.
A grease gun end goes right on the fittings.
they are greaseless
a grease fitting is something that u put a grease gun into and pump grease into it to lubricate ball joints, steering knuckles ect...