answersLogoWhite

0


Best Answer

you cannot manually roll up the window. I disconnected the harness and used 2 wires to jump power from the cargo light socket to the harness, one way is up the other is down by reversing them.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you manually roll up the Rear window on 1992 ford bronco?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How can you manually roll up a 1986 ford bronco rear window?

If its the bronco XLT you'll have to take the tail gate paneling off the inside. The motor, gears, etc. for the rear window are located in there. I had the same problem with mine sometime back.


How do you manually roll up rear window 1986 bronco after tailgate panel is off?

Try lubing all moving parts then.....good luck using the motor


Where do you buy small stuff for a 95 Bronco need a dash switch for the rear window?

jeff's bronco graveyard.com


How do you remove the window in the rear hatch of a 1989 ford bronco?

To remove the window in the rear hatch of a 1989 Ford Bronco, the weather stripping around the window will have to be pulled back or pushed down slightly. This can be accomplished with a straight screwdriver or a putty knife.


How do you manually put down back window of bronco?

Remove panel on rear door. Also remove small rear access panel. Unplug the two wire connector cable that's connected to the rear window motor. With a cable connected to your battery apply voltage to the window motor connector in either polarity, the window will travel up or down, depending on which way you connect the battery cable. Most of the time the problem is the limit switch inside the rear door... is defective


What is the gear ratio for 1992 ford bronco Eddie Bauer?

most 1992 Eddie Bauer bronco's are 3.55 in the rear and 3.54 in the front. that's what mine is with a 351w (5.8).


1983 ford bronco rear window wiring diagram?

Buy an aftermarket of OEM Ford manual.


Is there any way to roll up the rear window on a 1986 Ford Bronco manually until i can find out what the problem is internally?

yes, you must remove the door panel and remove the window motor bolts enough to move the window freely, once you have it up you can put the window motor back in in order to hold it in place. it works if you get the teeth lined up trust me i just did it :)


Is there a wiring diagram for a the rear window in a 1995 ford bronco Eddie Bauer edition?

check any bronco group web site, membership is usually free and they have all the schematics for the back window wiring and more


Will the rear window of a 1992 explorer fit a 1999 explorer?

No.


How do you get the rear window up if it is down and the motor is bad?

take the inside of the door off and put up manually


Where is the rear window motor located on a 1996 Ford Bronco?

It is located in the rear tailgate. Remove the inner panel and the support bracket on the right hand side to see it.