A: Checking continuity is the same as checking resistance, therefore yes someone can determine the resistance at that particular current level
By checking the output V while operational. There is also a static test for resistance.
Because ordinary ohmmeters are calibrated to measure a range of resistance values that are significantly lower than the resistance of insulation. It should also be realised that we usually test insulation resistance while subjecting the insulation to a high electric field, which a normal ohmmeter is incapable of producing.
It is halved. coz voltage=current * resistance
It is called resistance Good conductors have a bad resistance While bad conductors or insulators have good resistance against the flow of electricity
An ohm is a unit of electrical resistance. A kilohm is 1,000 ohms resistance, while a megohm is 1,000,000 ohms resistance.
Some of the checks that can be done to an electrical device before checking electrical resistance include the proximity of other magnetic fields and other electrical circuits. Measure electrical resistance while at a safe distance from strong electrical circuits.
Check each fuse with a continuity tester - Set to OHM's Remove each fuse and connect leads to fuse - a good fuse with show continuity "0" resistance while a bad fuse will show "Infinity" resistance
By checking the output V while operational. There is also a static test for resistance.
By checking the output V while operational. There is also a static test for resistance.
A: SURE it can while open it will measure the potential when closed it will measure the small voltage drop due to the resistance if any.
While change occurs over time , there is continuity to the stucture of a society.
While change occurs over time , there is continuity to the stucture of a society.
While change occurs over time , there is continuity to the stucture of a society.
Systolic BP is a measure of blood pressure while the heart is pumping; diastolic BP is a measure of blood pressure while the heart is not pumping. BP is the pressure of the blood on the walls of the blood vessels.
There are many variations of the basic Wheatstone bridge circuit. Most DC bridges are used to measure resistance, while bridges powered by alternating current.
The thermistors are resistors whose resistance changes with the temperature. While for most of the metals the resistance increases with temperature, the thermistors respond negatively to the temperature and their resistance decreases with the increase in temperature. Since the resistance of thermistors is dependent on the temperature, they can be connected in the electrical circuit to measure the temperature of the body.
Because ordinary ohmmeters are calibrated to measure a range of resistance values that are significantly lower than the resistance of insulation. It should also be realised that we usually test insulation resistance while subjecting the insulation to a high electric field, which a normal ohmmeter is incapable of producing.